bolts

My Y pipe has bit the dust, as well as showing symptoms of bad cats. I ordered The Magnaflow 23120 and the matching second cat and I'm hoping to install them later this week. Here's my question: What bolts do I need for the cats? Does the kit come with the ones that I need? Can I cut the heads...

Wrapping up a timing belt job. Is there any special trick to tightening these four 12mm nuts that mount to the fan bracket studs- can't get any torque with a box wrench, and of course there's no clearance for a ratchet. Fan unit wants to spin free, and nuts are easily stripped. Cussing hasn't...

im looking for the front shock upper bolt/pins and the hardware that would go on a 78 fj40. Need to be in good shape looks like I'm a few years to late on oem. If anyone knows of a vender that sells them please let me know. I've found one vender but they are aftermarket and add up with...

Hey all, Pretty basic question but unfortunately my truck was too much of a mess to show a definitive answer... I'm getting ready to install my Downey V8 conversion bellhousing. I spoke with Jim and he mentioned I'd need to go to 1/2" Allen head screws to mount to his bellhousing. It looks...

While attempting to replace the pins for my horn, I managed to seriously strip two of my steering wheel screws. Of course they're both still attached to the steering wheel. I've tried the typical punches and other extraction devices and had zero luck. Anyone have any other tips, tricks, or...

Before anyone chirps in and says "get to the gym", this is my dilemma. MT links installed in the rear and this is the second time I've noticed a bolt coming out due to the nut coming loose. This second round, the nut/washer combo itself is gone and I'm lucky I didn't lose the rear end as the...

Hey all, I finally took my running boards off and I've got a question. Now I've got 2 of the little "hook" things left over, one on each side because the bolts are too tight to get at them. Well long story short I want them off pretty bad. How did you guys do them without cutting them?

Hi folks, I am in the middle of a head gskt replacement, head has been pressure tested and skimmed. I am thinking I should replace the cylinder head bolts as somme of the old ones looked shot and I am assuming they are stretch bolts anyway. I am having trouble here in Blighty tracking down...

I'm located in Canada, looking for parts for my 1991 FJ80- random stuff mostly that I don't really care where it comes from. - rear washer nozzle (rubber bulb above the rear glass) - 4x seat bolts - fender flare hardware for the rear 4 fender flares. (Cage nuts and bolts, about 8 of each) - 1x...

I have a new to me FJ60 with a 62 front end. I noticed a seeping leak in the front differential, and, and further inspection, noticed that it is missing three bolts, so I am not surprised its leaking. Is there anything special about these fastening bolts or can I just find bolts and washers at...