Hi all! Long time lurker and hopefully a future fj40 or fj55 owner. In the meantime, I picked up this beauty a few weeks ago. 2000 with 240k miles. No rust. Lived here in Boise since 2003. Took it to the local shop to get everything baselined and am getting an Ironman foam cell pro 2” lift...
Hoping someone can help me with this one. Somehow over the last 23 years the two fasteners that hold the back plate for the blower motor resistor on my ‘89 62 have gone missing. Never notice it until I go to move temp from cold to hot this time of year. The loose plate and resistor keep temp and...
Hi all I just took apart my blower motor, cleaned it, and replaced the brushes and now its slower than before. I tried some with short 1/4 inch l;ength brushes and 1/2 inch brushes as well and while the shorter brushes made the rpm faster than the longer ones, they still both were barely usable...
My a/c fan blower died. Water on the passenger side floor board. Motor plug and the drain tube from the blower housing were wet. Verified the fan switch turns on 12v at the plug on the side of the blower. I guess the contacts in the fan are corroded but I haven't taken it apart yet. It's...
I'm at the local parts counter and hoping for help with quick question. My 94 heater ac blower assembly shows part number 87103-60140 which is NLA "discontinued".
There is part number 87103-26020 which IS available but parts guy says description in his system description says is "non-AC...
Going through my closet and I have the following items for sale - pulled from a 1986 FJ60:
- Front blower motor, functioned fine when pulled (Toyota Part # 87104-90A00). Should fit any US-spec, 12V FJ60 or FJ62. $75 shipped in CONUS.
- *** SOLD *** Aftermarket FJ60 grille (Taiwan), mounted on...
Hey gang, I created this 3d printable blower wheel for folks adapting the 92 Ranger blower motor to an early FJ40. This can be printed on any SLA or SLS printer (I don't suggest using an FDM printer like a prusa or a creality, the layer line orientation will make this part weak in key areas) or...
So ever since I purchased my lc 100 the blower will not fully turn off. All other speeds work but but the led will not move to off and stay on low or auto depending on witch way you turn the fan speed nob. Not a huge issue but annoying until this week it decides to stop working all together...
Hey,
I wanted some advice about how to fix my front blower motor.
A while back my front blower motor in my 97' LX450 stopped blower air, it's started getting real hot so I'm trying to fix it up.
As it stands right now, the rear blower motor is working, the heating is working but the front...
About a month ago I was tried turning on my heater in my 1988 FJ62. It did not work. As I accelerated on the highway, I noticed that the air coming into the car was warm. I also tested out the cold. It also worked but would not blow in any of the positions between low and high. I moved the...
1967 FJ40 Blower, Duct, Heater and Controls. Took out of my rig when I put AC in. Fan works, needs to be oiled. Heater core needs to have the nipple re-brazed. Otherwise all good. Have one side defrost duct and fitting.
Make me an offer...
Located in Houston TX
I put in AC so I...
I was hoping someone could point me in the right direction for the location of the blower relay. I have replaced the blower motor resistor, but now only the hi and low speeds work. Speeds 1, 2 and 3 are all low speed and then I have high. I'm thinking there is another resistor or blower relay...