bj40

I have a BJ 40 , w '79 Motor. Any one have experience with substituting a NON Fan Clutch water pump for an original ( leaking) water pump WITH Fan Clutch ??? The original is apparently discontinued. Anyone know of a source? It would seem that the length of the water pump shaft that the fan...

Up for sale is my 1980 Toyota Land Cruiser BJ41. It is right hand drive, imported legally from Japan almost two years ago. I have a Nevada title for it, and have had plates on it and insurance here in Nevada. It will pass diesel smog but of course it doesn't have to because of the age. Make...

I have the front drum brake assemblies off my 83 Middle East spec 40. $20 plus shipppng for the shoes and cylinders. Wheel hubs, backing plates and hardware, and large pattern knuckles are free if someone wants to pay to ship them. I will probably scrap all this but want to see if someone...

Genuin new discontinued part Some scratches exist. $155 shipped.

Please check out my rig at this cl post: 1982 BJ42 Toyota Landcruiser Thank you

Toyota Land Cruiser FJ40 Jump Seats | eBay

Need a right front fender Thanks

Hey everyone, Finally I got the BJ I always dreamed of....hold the laughter... But seriously, my 78 BJ40 just arrived from Costa Rica, I have not had a lot of success getting her to start, despite the engine turning over without fuss before she as shipped. 1. I connected the battery but...

Imported from Japan all documents included with sale. 2b diesel engine, runs great. Surface rust in several places, but nothing major. Price is 7k firm.

Looking for some dash knobs for a 79 BJ. Let me know what ya got thx

I am open to new or used kits Thanks

Hello, I just replaced my EDIC motor and also gave it a brand new relay. My EDIC motor is shutting off the engine without key switch. It will idle for about 10 seconds then shut down. Any clues as to what is causing this? Thank you

Hey, im looking to start restoring my 1980 bj40. It currently has a B engine in it. It comes with the usual 40 series look such as paint fade, rust and an oil leak from the rear diff. Which i would like to rectify. When its all said and done i would like to have a 1hdt engine and a h151f box...

Hello to keepers of all Yota knowledge! I have a 1984 BJ40 that the PO cut a hole in the left apron for a snorkel but he never connected it. I am looking to remove the snorkel and put one on the right side close to the air cleaner. I have been looking at hood aprons to replace the one with...

Hi there, thank you Nick for recommending me to check out iH8Mud! Very impressed and excited with what I’ve seen on here so far. Hereby for sale in California: “Olivia” 1979 Land Cruiser BJ40 3 Liter Diesel w/ manual 4-speed OEM #653 Olive on Beige interior Second owner Out of my own...

Hi there, Recently rebuilt my Toyota B engine, and ended up getting a sponsorship from Cummins. www.CleanCruiserProject.com The rebuild has roughly 700 miles on it. What I've done (All parts sourced from Engine Australia): New head Reseleaved (Not just honed) New Cam Reground Crank 1mm...

I have a rest of world 1984 BJ40 with a B diesel which I believe is stock. What do you think the block number is from the photo?

Anyone know if seats from any other Toyota models were the same as the FJ40 seats? I am looking at a pair of 1982 Toyota Cressida seats that look very similar.

Hi All. I have a 1984 BJ40 and I need new liftgate struts. I followed an old thread with a NAPA part number but it didn't sound like a direct replacement. I even called a store in the US and they can seem to pull the part and look at it and tell me about the brackets. Does anyone have a...

I have a 1984 BJ40. Anyone know of other Toyota models that would use the buckets same seats and/or frames. Mine are non OEM and would like to find the right ones in the Junkyard. Thanks!