Howdy! First time posting...
I have a 78 BJ40 that I’ve been rebuilding, and when firing it up for the first time, exhaust smoke was excessive, sometimes grey, sometimes darker and would calm to almost normal when bringing RPMs up. Attached are a few photos illustrating the changes as I start...
Would like to hear from anyone who has successfully completed a 4-speed gearbox conversion into a 5-speed gearbox.
If so, what was the improvement and are there any long term issues with any of the components used to align the system?.
What speed difference has been noted on the B Type Diesel...
Hello all,
I posted once or twice on here several months ago seeking input to inform my choice of land cruiser. After looking at dozens of them, I came to the realization that rather than finding the perfect cruiser, I needed to look through the superficial parts to find the perfect bones of a...
I have a BJ 40 , w '79 Motor. Any one have experience with substituting a NON Fan Clutch water pump for an original ( leaking) water pump WITH Fan Clutch ??? The original is apparently discontinued. Anyone know of a source?
It would seem that the length of the water pump shaft that the fan...
Up for sale is my 1980 Toyota Land Cruiser BJ41. It is right hand drive, imported legally from Japan almost two years ago. I have a Nevada title for it, and have had plates on it and insurance here in Nevada. It will pass diesel smog but of course it doesn't have to because of the age.
Make...
I have the front drum brake assemblies off my 83 Middle East spec 40.
$20 plus shipppng for the shoes and cylinders.
Wheel hubs, backing plates and hardware, and large pattern knuckles are free if someone wants to pay to ship them. I will probably scrap all this but want to see if someone...
Hey everyone,
Finally I got the BJ I always dreamed of....hold the laughter...
But seriously, my 78 BJ40 just arrived from Costa Rica,
I have not had a lot of success getting her to start, despite the engine turning over without fuss before she as shipped.
1. I connected the battery but...
Imported from Japan all documents included with sale. 2b diesel engine, runs great. Surface rust in several places, but nothing major. Price is 7k firm.
Hello,
I just replaced my EDIC motor and also gave it a brand new relay. My EDIC motor is shutting off the engine without key switch. It will idle for about 10 seconds then shut down. Any clues as to what is causing this?
Thank you
Hey, im looking to start restoring my 1980 bj40.
It currently has a B engine in it.
It comes with the usual 40 series look such as paint fade, rust and an oil leak from the rear diff. Which i would like to rectify. When its all said and done i would like to have a 1hdt engine and a h151f box...
Hello to keepers of all Yota knowledge! I have a 1984 BJ40 that the PO cut a hole in the left apron for a snorkel but he never connected it. I am looking to remove the snorkel and put one on the right side close to the air cleaner. I have been looking at hood aprons to replace the one with...
Hi there, thank you Nick for recommending me to check out iH8Mud! Very impressed and excited with what I’ve seen on here so far.
Hereby for sale in California: “Olivia”
1979 Land Cruiser BJ40
3 Liter Diesel w/ manual 4-speed
OEM #653 Olive on Beige interior
Second owner
Out of my own...
Hi there,
Recently rebuilt my Toyota B engine, and ended up getting a sponsorship from Cummins.
www.CleanCruiserProject.com
The rebuild has roughly 700 miles on it.
What I've done (All parts sourced from Engine Australia):
New head
Reseleaved (Not just honed)
New Cam
Reground Crank 1mm...