Recent content by Skitz

  1. Skitz

    LC280 - 3UR / AB60F in an 80

    Why would you pass on this swap? The 3UR has been swapped into an 80 chassis, reference UZJ40 builds....
  2. Skitz

    LC280 - 3UR / AB60F in an 80

    I am also doing a 3UR swap but I am going the Ford SD axles route. Sterling in the back and Super 60 up front. So many options gears/lockers/parts/etc.... I haven't started my swap... just collecting parts right now tho.... I'll be watching here... Good luck!!
  3. Skitz

    FJ40 on FJ80 with 2UZ

    I'm sorry to hear, I was looking forward to this build. I wish your family the best.
  4. Skitz

    2026 ACC Family Reunion Campout

    Count me out.... I'm on work travel... One of these years I'm gonna make it out....
  5. Skitz

    2UZ-FE to H55F Bellhousing Adapter Kit Now Available!!!

    Similar question.. For a 40, how's the 2uz placement to the firewall.... Can you access the starter bolts from the tranny tunnel?
  6. Skitz

    2UZ Swap info

    Talking about Rads... I'll toss this piece of information.... If you have an FZ Radiator, you can run a Mitsubishi Outlander 2003-2006 2.4L Radiator Electric Fans. A little trimming & tabs, and this Radiator Fan falls right into a 1FZ Radiator. It is a perfect fit.... I am running a DORMAN...
  7. Skitz

    2UZ Swap info

  8. Skitz

    93-97 OEM Rad in a 92 cruiser

    Yes a 1FZ rad will bolt right in... no fitment issues... I am running a 1FZ rad from my v8 conversion in my 91...
  9. Skitz

    FJ40 on FJ80 with 2UZ

    Good luck with this build! Gonna be watching for sure... Since you got a 2003 4runner, if you or know a good transmission guy, you can convert the 4runner tranny to LC tranny... you just have to rip it apart to get at the rear housing/output.... There's a post somewhere on here where a guy...
  10. Skitz

    Pre-03 nav delete how-to

    That fuse is for your Rear Window Defogger and Mirror heater. Double check or swap out your Gauge Fuse.
  11. Skitz

    Pre-03 nav delete how-to

    Check your fuses... make sure you didn't pop/short something
  12. Skitz

    2UZ Swap info

    Been watching/waiting for this build... Glad to see it moving again...
  13. Skitz

    91 fj80 2UZ swap

    Here is a good reference for 2uz swaps. I also did a 91 2uz swap and you can see my build. https://forum.ih8mud.com/threads/2uz-swap-info.1352519/
  14. Skitz

    The definitive "What’s really required to fit 37’s w/o cutting sheet metal" thread

    I'm running 37s (13.5 wide) on a 3" lift OME J Series with no cutting sheet metal... The key was pushing the axles out. I used Delta 3L arms to push the axle forward 1" and Landtanks Extended Lower Arms to push the rear axle 1". Then I extended the bump stops using Slee's and Parry's...
Back
Top Bottom