FYI - for anyone who does wind up replacing the actuator assembly, an 80-series actuator is usually cheaper than a 100-series actuator. You just have to change over the connector and adjust the actuating rod by a tooth or two to line the threads up up with the bolt hole in the fork on the...
Finally buttoned up a complete overhaul of the rear brakes. New everything from the axle flex line onward, plus a ton of restoration of the parking brake hardware and pivots and new bellcrank boots.
I actually enjoyed making new hard lines for the axle, and everything feels a lot better I'm...
Added Well Visors and painted my hood (plus a 2" strip on the top edge of the fender) with raptor liner to cut down on the glare when I'm driving due east/west at sunrise/sunset (and to cover up the failing clear coat). Both make a big difference on trips. Next thing I need is a gradient tint...
Finally knocked a bunch of little upgrades off my list.
New steering wheel cover from Amazon/Loncky (it was a super tight fit - I wound up needing to trim some of the original leather off the spokes and use some heat the stretch the leather ... the end result being it's now a little loose in...
Sure thing. Hope you just poured a cup of coffee because I just finished my coffee before I wrote this 😅
My dash is an exercise in continuous improvement, so here's the current state, soon to change:
For the phone holder, I use @BenCC 's "M34 - Hazard/DiffLock Switches Swap Kit" and "M2 V2...
The CB antenna itself is a Firestik Firefly CB Antenna - 4' / Red, mounted with an External Locking CB Quick Disconnect to a lightly modified Adjustable Universal Hood Mount, and wired up using 12' Terminator Coax Cable with FME. I get most of my radio stuff from Right Channel Radios, which is...
Trip update: it was raining in Milford, DE ...
It was raining at Dover AFB ...
It was raining in Drumore, PA ...
And it's raining here in Cunningham Falls, MD ...
But I'm so happy to be out on the road 😁 Love this truck
I keep having to cancel trips for life reasons, but the upside is I'm slowly knocking off things on my to-do lists.
Finally fixed the wonky rear bumper alignment and installed the front ASAP flaps and set up the retention screws & rear retention pin. I guess this truck backed into something...
I would try to place it up high towards my shoulder so I could hear and key it without taking it off the belt, but often found it more natural to just take it off the seatbelt and hold it in my hand
Gamiviti makes a mic holder for seat belts that I kind of like. I picked up a few of them a couple years ago.
https://www.gamiviti.com/mic-holders
Pic from their website:
I find that I'm way too fidgety and I get in and out of my truck too much for it to not send the radio that I forgot...