Recent content by Dirt J

  1. Dirt J

    98-02 Charcoal Canister Solution by Cruiser Patch

    What about reprogramming the ECU or using inline resistors (?) to make the needed reading so we can use the overseas canister? I don't *think* we have to worry about that part going away soon?
  2. Dirt J

    Unknown Fluid…Red and Sticky. Odd location

    If they are original, they will need to be replaced.
  3. Dirt J

    Unknown Fluid…Red and Sticky. Odd location

    In the FAQS here.
  4. Dirt J

    Unknown Fluid…Red and Sticky. Odd location

    Agree with others. Leaky heater tees would make sense given both of conditions (losing coolant and location of drip.) Trans fluid would be a long shot. Cruiser Patch usually has the nice metal heater tees in stock ready to ship.
  5. Dirt J

    Unknown Fluid…Red and Sticky. Odd location

    Transmission fluid is red...? Did you check the dipstick and breather vents for the trans?
  6. Dirt J

    2000 Land Cruiser transmission woes

    Another 2000 model year here with 348k and counting daily driver.
  7. Dirt J

    Front LH ABS Speed Sensor connector

    Red wire goes to terminal 2 and green wire to terminal 4.
  8. Dirt J

    Build Dirt J "Dirt Cruiser" Build

    Well, that NOS NAPA alternator appears to be failing. Voltage is still in low 13v range even with the fancy HKB voltage booster (upgraded from the GM diode thing). Since I didn't turn in my old Denso as a core, my current plan is to see if a local rebuilder will do that to the Denso, and I'll...
  9. Dirt J

    LX470 ARB bumper radiator skid plate

    Yes, that's it. See here too. Mine has held up better than I thought it would when I first saw it.
  10. Dirt J

    Build Patch's Build Thread

    When does the retrofit kit drop on cruiserpatch.com?
  11. Dirt J

    100 Series HVAC Controller - NAV DELETE - (OEM+)

    No. The 2nd row floor vents come from a dedicated heater core under the left-hand front seat. It's heat only.
  12. Dirt J

    Rear Control Arms Removal and Replacement

    Yes ratchet straps that parallel (ish) the arm you are removing and a jack under the axle will help with alignment. Big pry bar wouldn't hurt either.
  13. Dirt J

    What have you done to your 100 Series this week?

    Slee makes a complete replacement insert that I've been eyeing. One of my plastic housings is busted.
  14. Dirt J

    Build Patch's Build Thread

    I think you retrofitted the wrong steering component...
  15. Dirt J

    Check engine light

    Grab the codes and report back. Any parts store will give them to you. Why did you replace the cap?
Back
Top Bottom