- Thread starter
- #61
I piddled around with the wiring and fianlly the tank was dry and I dropped in place and test fitted the end. I also added a new grommet to the floor. Like a glove.
Then I started to assemble the other side once I cut the line to length. I actually cut it with a cut off wheel as the SS was so tough. Here is a pick of the fitting itself.
And assembly pretty much the same as before but this fitting is made by Earls so it is a bit different.
Then I started to assemble the other side once I cut the line to length. I actually cut it with a cut off wheel as the SS was so tough. Here is a pick of the fitting itself.
And assembly pretty much the same as before but this fitting is made by Earls so it is a bit different.