This car donated its heater valve. I've seen these listed for 90s SC300 and SC400. It works great.
What have you done to your Land Cruiser this week? (24 Viewers)
- Thread starter IH8MUD
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
This car donated its heater valve. I've seen these listed for 90s SC300 and SC400. It works great.
That’s really clean work with the filler neck. Looks like it could have been factory.
I got the first 4 coats of primer on the tub yesterday 
#fj40_build_nz
#fj40_build_nz
I got the first 4 coats of primer on the tub yesterday
#fj40_build_nz
View attachment 2155588
View attachment 2155589
View attachment 2155590
What air compressor and gun are you using?
That is great looking. That piece on the wheel well, did you fab that or is it a stock part off something else?
Stabbed the transmission and transfer case
OEM relocated.
It took me a minute but now I understand. Thanks.
Hmm I have tried multiple times and nothing. I'll get this figured out
Big day. Got the tailgate cables installed as well as the basket hitch mount fabbed in.
Started de-rusting of the heater housing
samatulich
SILVER Star
Finished up cleaning the wiring mess under the hood. Made a couple ground wires to go along with the set from @Fourrunner (battery to frame,battery to pass/fender, frame to engine, frame to starter, frame to firewall). Cut to length the winch power cables and covered in plastic split wire covers.
Also added a ground from both front marker lights to respective fenders. Was having issues with the turn signal lights not working, so far I think this has resolved those issues.
Installed the fusible link that @Coolerman made up for me, been sitting on it for a couple years now.
Lastly I used the location of the charcoal canister to mount my auxiliary fuse block.
Picked up some new cordless power tools too. Been looking at these for a couple years now. After using my brothers this past September to replace the rear diff, and clutch I realized how nice they were to have and use.
Rotated the tires, had just over 8K on them and want to be more vigilant about tire rotations in general. I included the spare in the rotation, so far everything seems to be wearing very evenly.
Also added a ground from both front marker lights to respective fenders. Was having issues with the turn signal lights not working, so far I think this has resolved those issues.
Installed the fusible link that @Coolerman made up for me, been sitting on it for a couple years now.
Lastly I used the location of the charcoal canister to mount my auxiliary fuse block.
Picked up some new cordless power tools too. Been looking at these for a couple years now. After using my brothers this past September to replace the rear diff, and clutch I realized how nice they were to have and use.
Rotated the tires, had just over 8K on them and want to be more vigilant about tire rotations in general. I included the spare in the rotation, so far everything seems to be wearing very evenly.
Custom sliders came today from Dave at 4 Plus Products. He customized them for me since I’m stretched. As always amazing quality with excellent customer service.
Made a beach run with the locals.
reddog90
SILVER Star
Drove it to the beach
Started to rework the wire harness for some updates, and properly train it with the dash removed. I get my new lens tomorrow so the work will slow down for a bit. It will be nice to see out of the left eye again tho.
Oh I don't even want to think about how many of those little '?' tabs I'm gonna have when I do this!
