What do I need?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 5, 2004
Threads
183
Messages
2,217
Location
Reno NV
I recently bought a rear heater for my 76 FJ40, but I know I don't have the proper setup. I'm not sure what exactly I'm missing so pictures might be good if you have them. So far I know I'm missing the 2 pipes that run from the pipes coming through the firewall, but what else is there? Can/should I make these pipes myself?
Here's what I have...

Just imagine there is a rear heater there.
1578635351830.webp


1578635564477.webp


1578635047339.webp
 
Your missing the T lines that go to the front heater that supply water the the rear and lines to the rear

You could just use the line out from the front heater ... plum that to the rear Then back to the firewall

Or visa versa

I have had it that way for years
 
I'd recommend replacing the cracked cowl drain tubes with heater hose and hose clamps while you are at it. Nothing worse than finding rain under the factory floor mat, or between the gas tank and the tub.
 
These are the firewall heater pipes @JohnnyC is talking about:

View attachment 2178311

Good thread with pics: -> click here <-

Thank you, I found these pipes on eBay and purchased them. They don't have the insulation foam on them, is that an issue at all?
So now I think I just need the pipes that run to the rear heater.

I'd recommend replacing the cracked cowl drain tubes with heater hose and hose clamps while you are at it. Nothing worse than finding rain under the factory floor mat, or between the gas tank and the tub.

Where's a good place to get some of these?
 
heater hose is a generic item at the autoparts store
 
If I recall correctly, my rear heater uses a smaller diameter than the front, making it step-down then step up depending on how they are run.
 
heater hose is a generic item at the autoparts store


Yeah for the later drain just use a generic heater hose that fits the barb on the bottom of the cowl.

Earlier years there's a reproduced hose but that one bends and exits to the engine bay instead of transmission tunnel.
 
Back
Top Bottom