What Did You Do with Your 80 This Weekend? (32 Viewers)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Spent three hours claying the rust specks off of the hatch and tailgate. I guess they came off of my ballmount or the rusty "stainless" bolts that came with my LED pods.
 
Mounted this...
09426894849247-vi.jpg


75 bucks shipped off amazon..
 
Managed to get a few projects knocked of the Cruiser project punch list.

On Thursday I had a my exhaust replace with lightly used stock components (thanks VanGo) and Walker cats...turns out the rear cat was faulty from the factory. It was leaking at the seam where the two halves are welded together. So I have deal with a leaking exhaust until my exhaust guy can make the repairs next week.

Today I did some work on the steering system. The slip yoke was seized up on the steering shaft and would not allow the appropriate adjustments without removing the steering box. Now everything slides like is was meant to and was able to align my steering wheel properly. I also put in a new seal at the firewall where the steering shaft passes through.

And greased the drive shafts and emptied the PCV catch can.

The pile of parts is finally starting to dwindle!
 
Last edited:
Tippity top of the cinders, baby!
ImageUploadedByIH8MUD Forum1405230232.094503.jpg
 
Hitched up the Rzr and hit the offroad park ab 30 mins from town. Trailer weight of around 2,000 pounds was noticeable on every over pass. The tall ones required some full throttle action.

If course, the ac was also on full blast since it was 100* outside.

20140712_191200.jpg
 
What park did you go to?
 
Just bought this. Hopped on a plane to reno and drove her back to san diego. The driveway looks much better now!
IMAG0518.jpg
IMAG0521.jpg
 
Last edited:
Got around to putting some paint on my sliders and cross-member/skid plate combo that I got from Mike at Bump it Offroad. If you need armor Mike is awesome to work with and he accommodated my wishes to customize the tube on the sliders to act as me of a step,, Cannot wait to find time next week to install them.
DSCN1287.JPG
DSCN1288.JPG
DSCN1289.JPG
DSCN1290.JPG
 
Got my head gasket job finished up , and drove the cruiser for the first time in 5 weeks... Runs sweeeeet!
 
A little wheeling in CT. with Yankee Toys. Good time.
gremlingraveyard10_zps3bc5f20e.jpg

gremlingraveyard9_zpsa2a968f2.jpg

gremlingraveyard2_zps93ac80f7.jpg

gremlingraveyard6_zpsa317b267.jpg
 
Very nice and a reasonable price! Your engine bay is as clean as mine!
2013-10-13203656_zps6c792da8.jpg
Dang!!!! What do you use to clean it with? I need a good safe product.
 

Users who are viewing this thread

Back
Top Bottom