Weathertech digifit front liners for 80 series are here

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Can't wait to see the tan and dark brown options i think they look amazing. But I agree if these are injection molded they could have easily moved the hole to accept the factory hook.
 
Y'all quit pissin' and moanin' about the damn clip and be happy we got them. I've used these for the last 8-9 years in different vehicles and they are, without a doubt, the best option possible.
 
Looks like a nice fit. As expected.

Not sure I'll be tossing my Husky's yet though, these WT don't look like they would hold very much liquid. Down here in the valley, I'm surrounded by 1/4 minus gravel, so they will be great. But wintertime in Flagstaff, I question how much snow melt they'd handle.
 
But aren't they too expensive? Anyone with $5 of plastic can make these themselves. :)

Actually I am really surprised these materialized. Wouldn't have thought the market was big enough for them to make the moulds.

Actually, I'm saving my plastic bottles to make front radius arms. Saves on weight you know... :hillbilly:

Someone in the marketing department is going to look at the initial sales orders (via mud) and think it was a good decision to bring them back, then wonder why things dry up in a week or two. :D

I just can't believe how quick they shipped.
 
ok, now I am really interested to see if they choose the lighter brown or the darker brown for their "Tan".
 
Here are the brown color.. Will get better pictures out in the light
ImageUploadedByIH8MUD Forum1408802364.361107.jpg
ImageUploadedByIH8MUD Forum1408802378.594221.jpg
ImageUploadedByIH8MUD Forum1408802391.510436.jpg
ImageUploadedByIH8MUD Forum1408802403.012247.jpg



Sent from my iPhone using IH8MUD Forum
 
Actually I am really surprised these materialized. Wouldn't have thought the market was big enough for them to make the moulds.

That's what they replied to me all ten times I emailed them asking them to make them... assuring them there were plenty of people that would buy them.
 
But aren't they too expensive? Anyone with $5 of plastic can make these themselves. :)

Actually I am really surprised these materialized. Wouldn't have thought the market was big enough for them to make the moulds.

I'm surprised too. I wonder if they have a new manufacturing process to allow them to make the numbers work on smaller volumes?
 
3d printing. Things are so much easier now with 3d mapping arms and 3d printers. They pull a vehicle in, run the mapping arm over the floor, probably print out a model section of that floor, reduced say 1/4" and then make their mold.
 
I used to manufacture RC helicopter equipment, I vacuum formed canopies for the helicopters. Once you have the molds made you can produce product at your own pace. As scott stated above the advent of 3D lazer mapping and 3D printing has changed the game. The material I used to make canopies was expensive, it was aluminum filled and held heat just right to help the molding process.

They have the molds now, wont take them long to recover the cost of the molds and figure out what sells best and stock it. Three months from now they will offer same day shipping from stock. I'll be buying a set for at least two 80s at this point.
 
anybody drive with them yet?
 
I don't think I will be able to hold out for Amazon Prime. The tan look so good. My floor mats are see through in some areas.
 
Can't wait to see a picture of gray.

But I'm confused - are these different than the other ones on their website listed under the vehicle application? The ones I found didn't mention digital fit unless I just missed it


...via IH8MUD app
 

Users who are viewing this thread

Back
Top Bottom