Thread size?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Feb 4, 2008
Threads
80
Messages
542
Location
Sebec, Maine
I've got a F135 engine sitting in my shop and I want to do a compression test on the cylinders before selling it.
So I need to make a bypass hose between the oil pressure regulator and oil inlet to the engine. I thought the threads were M10x1.00 straight but it doesn't like my tap. Can anyone verify or correct me on the correct thread size. Thanks
 
A quick thread search consensus is that It's 1/8" BSPT.

Not confirmed by me.
 
You know how it goes, you write a thread then think about it. Tapered thread explains the tap issue. I think I've got a 1/8" BSPT tap.
Let you know unless a confirmation appears before hand.
 
I’m not sure why, but I think @Splangy knows the answer to this.
 
More like 3mm I think.
 
I've got a F135 engine sitting in my shop and I want to do a compression test on the cylinders before selling it.
So I need to make a bypass hose between the oil pressure regulator and oil inlet to the engine. I thought the threads were M10x1.00 straight but it doesn't like my tap. Can anyone verify or correct me on the correct thread size. Thanks



is this really what u need as a end goal ?



DSCN7898.webp
DSCN7899.webp
DSCN7900.webp
 
That remote oil unit looks pretty handy Ragingmatt.

So 1/8" doesn't have anything to do with the diameter since that would be 0.125" not 0.383". Good to know, I sort of learned something except what the conversion factor is.
 
@middlecalf :

Pipe sizes don't have 'conversions' in the fractional size area. Once you get to 1" NPT and larger, there is some semblance of size and I.D., but it's 'nominal' and not actual.

There are British Standards and (USA) National standards for pipe threads. There a few BS and N sizes that are close, but NOT identical.

The only way to determine fractional sizes reliably is to look up the thread specs and compare to the pipe threads you're looking at. For FJ40's, all the pipe threads I've ever encountered are BSPT (British Standard Pipe Tapered) for openings in the block, head, and fuel pump, or BSPP (British Standard Pipe Parallel) for swivel fittings attached to hoses.
 
Back
Top Bottom