Builds The Boujee beater

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

I am going to be more active this year on the east coast. Hope to see you at a run! I think we are going to try and hit the northeast in 23 for all the events we can.
Well hopefully @GXO can make it to the CLCC Fall Crawl. It is normally held at the end of October at the Cove in Gore VA. It is a fun time with camping and wheeling. Typical East Coast style wheeling with a fair amount of rocks and depending on the weather mud as well.
 
I am going to be more active this year on the east coast. Hope to see you at a run! I think we are going to try and hit the northeast in 23 for all the events we can.
That sounds good Dan, would like to meet in person.
Coal miner, fall crawl, smoky mountain and relic run are all great events on the east side.
Let us know we you figure out where you might be heading.
 
Last edited:
That sounds good Dan, would like to meet in person.
Coal miner, fall crawl, smoky mountain and relic run are all great events on the east side.
Let us know we you figure out where you might be heading.
GSMTR is my traditional as it is only a few hours away. I would love to venture up to coal miner and points NE as I haven't really wheeled up there. We could bring the GX fleet and the refugee camp trailer and make a circuit! haha
 
GSMTR is my traditional as it is only a few hours away. I would love to venture up to coal miner and points NE as I haven't really wheeled up there. We could bring the GX fleet and the refugee camp trailer and make a circuit! haha
That would be excellent.
 
Fluid film black is a really nice touch.
801A3520-20E7-4518-BB68-AB421819944C.webp
219B9B14-D7D5-4688-A8D9-CD991B317F51.webp
 
GSMTR is my traditional as it is only a few hours away. I would love to venture up to coal miner and points NE as I haven't really wheeled up there. We could bring the GX fleet and the refugee camp trailer and make a circuit! haha
There should be a least a few GXs at coal miner. Hope you can make it
 
Emergency exhaust fix before flagpole knob this weekend. Not bad for 130 bucks.
Plus when I was checking the exhaust work I noticed I popped another snap-ring on a upper control arm Jonny joint.
All fix and ready for the weekend.
FD4BA4C5-824A-4832-BD72-E72E5A63B056.webp
66A11D0F-8146-4175-9343-68252EA94A89.webp
 
I’ve been fighting knocking these down and bending them up for a while, so I’ll try this and see if this works.
After
AEF86DDE-3383-4DAD-BB14-5882DC4D7D54.webp
980BB613-E35B-4E60-8F18-3ADF50DEB3DF.webp
BFBCCC1E-053B-427F-82C0-66450BA4BE08.webp
before
 
Just do a tiny little tack weld on the front edge and it shouldn't move at all. Mine hasn't in almost a year now.
 
What about the exhaust in the cabin?
 

Users who are viewing this thread

Back
Top Bottom