Techster’s 1973 FJ55 buildup...

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

I see, I think.

My inners are good. I think I'll just make some. I can roll sheet metal. I think I'd be OK with one set from IPOR, though. I don't need it to go all the way out to the end of the fender. I already made the panels on the fenders.
 
nice whatcha got so far
 
Got a bit distracted with school and work and other people's broken vehicles

I've got the roof about half drilled out. The rear corners cut out and some panels built for the inners. I hope to start blasting it in a couple of weeks.


Mostly I've been distracted by the 67 FJ40. I've been trying to get the engine dropped so I can get it off the hoist.

motor mounts. I <3 my plasma cutter.
MVC-024S.webp
 
Not much to report.

The stripping of the undercoating is going well

I've cut out a lot of rust along the quarters and rear corners. I haven't had a chance to take my little corner piece to the boneyard yet to see if I can't match it up to something.

I did take it to Farm and Fleet and found that a trailer fender is not close.
 
Getting soda blasted on Monday so I gotta finish up the undercoating and get the roof off this week.

The 40 fired today so it's going on the back burner until the 55 is done.

Anybody want a 67 rust bucket 40? You can take it as is or to any level of done-ness that you want. I've got too many damn projects.
 
Finished the undercoating as much as I'm gonna do before the sodablasting.

Stripped the doors and tail gate for blasting.

I still have to mask the 1/4 windows. I don't want to try and take them out and risk ruining the unobtanium gaskets.
derustproofed.webp
stacktobeblaster.webp
 
Nekkid Pig!!


Shes down to bare skin now. Camera batteries died so no 35% pics until tomorrow.


More rust, but nothing terrible and nothing I didn't really expect.

The big surprise was a 6 inch gouge through the sheet metal under a rear window and a caved in quarter.

I'm thinking about some trollhole quarter patches so I don't have to make wheel well flares.
 

Users who are viewing this thread

Back
Top Bottom