teatnus sow

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Here is a rear bumper I made

image-970452146.webp


image-223051806.webp


image-1265951389.webp
 
turn signal help

I cleaned all my grounds, disassembled and cleaned ts switch, opened up the flasher and cleaned contact. I have a good left turn signal, good hazzards. right turn signal works until i step on brake. the flasher module has two coils in it, and two plugs that have several leads apiece on them. am i backfeeding voltage when i step on the brake to the right signal. where did i go wrong? thanks for the help in advance.
 
Rear bumper is plastikote engine enamel 202 universal grey. Front bumper is krylon gloss pewter grey. Anyone have a better suggestion? Thanks for the any help on turn signals.

image-601431886.webp


image-2057354578.webp
 
Thanks tucker, that is my sons name as well!! Here are some door panels I made. I need some window winders, I checked napa. No luck. Where are you guys getting them? Thnks again

image-3402891538.webp


image-3853432741.webp


image-1881248893.webp
 
The magnets in my heater blower motor were no longer glued to the side of the housing. A new one was 120 bucks. I just cleaned and jb welded mine back on. It now works fine. My heater core now seems to be plugged.
 
I just wanted to let people know that the trun signal problem was remedied by running a tap thru the anchor screw retaining nuts on the rear turn signal. I must not have had a good enough ground. My Weber 38 that is brand new seems to use a lot of fuel, I have the mix screw set the way they are supposed to be set. I think I will try the smaller weber I have - 32-36 i believe. It also seems to be rich even though the stock jetting is recommended for higher altitude than I am at. I seem to have a small amount of black smoke under acceleration.
 
I am hoping someone has a cheap steering box. I just missed one on eBay that sold for $0.01. All my shims are out and the box is still loose. I don't want to tackle a scout box conversion right now. Thanks for any help. I just got done pulling my radiator to reveal my timing cover a second time. I used the anaerobic sealant this time on a new seal as the Manual specifies. I pulled my heater core. It reAlly wasn't that plugged. It still isn't that much air coming up thru the defroster vents. I hope it's adequate. Stuck some fire wall insulation In to cut down on noise.

image-499292230.webp
 
You must log in or register to reply here.

Share this page

Back
Top Bottom