Side steps=what are these worth?
- Thread starter ready
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
I have a nice set of the shorty ones if need be.. i'm now holding out for these longer repro's. So I can dig out the shorty ones if needed to send off.. And I think I could arrange free mudship later this spring to tx. Only if needed and sounds like you have plenty of offers.
Awl-TeQ
it looks like a P7 Pullmax
it looks like a P7 Pullmax
Need me one of them.
- Thread starter
- #27
Yes I can make them but they will be out of 14 gauge cold roll steel.
As far as price for the ones in this thread I am waiting for the rubber to get here to come up with a price. It's going to be as original as what came from the factory. They look real nice!
was the original rubber white only? or did they have black? the crusty set I have here has white.. well white crumbles.
i'm ok with white if it's "vintage" just like the old cars with white interior, gonna be kinda hard to keep clean.. Didn't know if black was offered back then. Keep up the good work.. gonna have to save my pennies, we have steps and hubcaps coming round the bend.. Sadly i have originals of both but they're rough and not worth the time with new stuff on the horizon.
How close are the fj45 ones to the fj40- hole pattern? FJ40 have the hard diamond plate surface vs the rubber. If they are different I'd be ok with the captured nuts and the support stiffener left blank with no slot/whole cut out.
The FJ40 had the same rubber as the FJ45. They changed to metal in early 1969.
Chinredneck I think your wanting plain ol running boards that are avail everywhere.. Many of us have those stacked up like cordwood. The ones in this thread were only on the very old trucks and unobtanium. Newer trucks went to the stamped diamond plate, the vintage iron was like the pictures in this thread.
You can find what your looking for at any of the major vendors or in the TLCA magazine go to the vendor section and look. The hole patterns are the same and while we could use the newer stamped style many of us are anal and what what was original to our trucks thus this opportunity arouse. If you are having trouble finding running boards for your style while we can help we are going old school here.
You can find what your looking for at any of the major vendors or in the TLCA magazine go to the vendor section and look. The hole patterns are the same and while we could use the newer stamped style many of us are anal and what what was original to our trucks thus this opportunity arouse. If you are having trouble finding running boards for your style while we can help we are going old school here.
The hole pattern did change when the steel diamond plate replace the rubber pad. Not all holes just a couple. I put my 68 on it's side many years it ruined the passenger's board. I replaced them with a set off of a 78. When I paint it I will switch back to stock.
1980 should have the ones with the notch in the side for the body seem, earlier ones didn't have that and are smooth where they mount to the tub.
be certain you get the ones you need.
try the classifieds section, sub section, wanted items
- Thread starter
- #38
Price info
Ok the set will cost $299. This will include side steps, outer rails, rubber material and 28 nuts, washers and bolts. I have several ready to go.
I have set up a pay-pal acct- so let me know who would like a set by sending me a pm.
I will be working on a set of shorties for those of you that are interested.
Thanks, Jesse
Ok the set will cost $299. This will include side steps, outer rails, rubber material and 28 nuts, washers and bolts. I have several ready to go.
I have set up a pay-pal acct- so let me know who would like a set by sending me a pm.
I will be working on a set of shorties for those of you that are interested.
Thanks, Jesse
