- Thread starter
- #101
UFI, my pump / injectors were rebuilt for 18PSI so prob will start there.
Build Roaming Lost: x3 Locked 1990 Toyota HDJ81
- Thread starter roaminglost
- Start date
-
- Tags
- 1990 builds expedition hdj81 truck
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
- Thread starter
- #102
Machining has begun!
- Thread starter
- #103
Like new!
very nice 
What kind of force you need to turn the engine in this condition ?
What kind of force you need to turn the engine in this condition ?
As you are rebuilding the HDT , what was wrong with it ?
Head gasket or piston failure?
Head gasket or piston failure?
- Thread starter
- #106
Minimal. Turns very easilyvery nice
What kind of force you need to turn the engine in this condition ?
- Thread starter
- #107
I’m excited to try this UFI 18G turbo.
With the help of a @adsinjection pump, I aim to get 200-250HP out of this new setup at 23-25 PSI.
With the help of a @adsinjection pump, I aim to get 200-250HP out of this new setup at 23-25 PSI.
If fuel pipes , IP , cooling , exsaust are properly tuned , you can easily go well over that goal.
Look into Yanmar similar motors
Look into Yanmar similar motors
- Thread starter
- #109
I'm not looking to get crazy, just more power and reliability.If fuel pipes , IP , cooling , exsaust are properly tuned , you can easily go well over that goal.
Look into Yanmar similar motors
- Thread starter
- #110
days away from it running again.
- Thread starter
- #111
ARP stud in. 40% more clamping power over stock = boooooost
- Thread starter
- #112
No hood hits different.
- Thread starter
- #113
$17k later, new motor...
More will be provided about this entire process on YouTube. It will be easier to gather all the information.
www.youtube.com/roaminglost
The cost was higher than I anticipated, but I can't argue that it was the better decision. A rebuilt motor with numerous upgrades and fixes along the way.
More will be provided about this entire process on YouTube. It will be easier to gather all the information.
www.youtube.com/roaminglost
The cost was higher than I anticipated, but I can't argue that it was the better decision. A rebuilt motor with numerous upgrades and fixes along the way.
Last edited:
- Thread starter
- #114
These took a minute to get, but they're pretty nice! I do regret not getting the rears, tho...
www.nobullaccessories.com.au
Car Commercial 4wd Floor Mats for Sale | No Bull Accessories | Sandgrabba Floor Mats
If you're interested in purchasing 4wd floor mats or moulded 4x4 floor mats, check out No Bull Accessories! We offer a variety of products on our website.
www.nobullaccessories.com.au
- Thread starter
- #115
Swapped my 350mm wheel to a 380mm. It's much nicer to steer with.
- Thread starter
- #116
35s vs 37s
- Thread starter
- #117
It took me a couple of days, but I finally hooked up these Holley RetroBrights. I didn't know about the negative switching deal. So learn from my mistakes and get this too.
- Thread starter
- #118
2500 miles in on the rebuild and it's going great!
- Thread starter
- #120
I love driving this thing!