ripping out a leaf spring(s)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Oct 8, 2006
Threads
2
Messages
25
Location
Victoria, Australia
Hey all,

I own a '78 fj40 that i pretty much rebuilt from scratch, i have replaced nearly everything including the suspension... twice!!! The ride is still so hard that a speed hump strikes fear into the heart of me! i have another mate with a '68 which is totally bog stock and his ride is beautiful! I have a full 'ironman' setup with lifted springs and gas shocks and whenever i hit the smallest bump, it feels like i'm getting kicked in the back of the head!
So my question is... If i pull out a leaf (or 7!) which leaf(s) in the pack would soften her up a bit?
 
So my question is... If i pull out a leaf (or 7!) which leaf(s) in the pack would soften her up a bit?

I would start by pulling out 2 of the shortest leaf's. You will loose some height, but that isn't necessarily a bad thing.
I think I ended up removeing the 3 shortest leaf's and installing 1 full length.

Another thing to consider is your shackle angles.(or lack of any angle) This can make a huge difference.
good luck.

aw
 
I have ridden in a truck once with the Ironman springs, and like you said they were incredibly stiff and bouncy.

Flex the truck out in one direction, let it sit for a couple hours, switch directions, let it sit again.

Doing this a few times will definatly help, as well as removing the bottom leaf or two.
 
Another thing to consider is your shackle angles.(or lack of any angle) This can make a huge difference.
good luck.

aw

That is not my experience.

I had heard this so much that I went to the trouble of relocating my shackle hanger after instaling new springs and I didn't notice much of a difference in ride quality, although I did get a little more droop out of my suspension. I guess it depends on what you mean by huge, but to me, it was barely noticible. Not worth doing in my opinion if you are expecting a "huge" improvement in ride quality.
 
Thanks for your help everyone, just one more thing though? What's the easiest way of flexing it out? I'm in the middle of a full rewire, so it's not exactly running at the moment!

Cheers.
 
Ramps. Front right and rear left for a couple of hours. Then, swap. Front left and rear right for a couple of hours. Do this a few times and you should feel a difference.

Good luck!
 
I was unimpressed w/ the ride of my 4" Skycrappers that I removed the 2nd from the bottom leaf, redrilled them 3" back, & shifted the rest of the pack to align. I tore all that leaf spring crap out & am running coils now. I sold the springs a while back & noticed they had sagged quite a bit. I guess I'd suggest finding a leaf pack with more but thinner leaves (?) I dunno.....
 
I think that i will try the sand bags method, then if that doesn'y work i'll start pulling springs! Coil springs would be my wet dream but don't have the cash and it's bloody expensive to engineer it all.
 
I had the ironman springs, still have them in the front. The shackle angles have never been good, I had longer main leafs made for the rear which helped greatly. The shackle angle on the rears was terrible. The front are somewhat acceptable but are hopefully being removed soon. I have had them about 6 or 7 years and they haven't settled much. They are definately stiffer than the 45 springs I have in the back now.
 
One thing not to over look is excessively tight shackle bolts/nuts. If there is way too much pressure on the shackle, they will hesitate "swinging" when they hit a bump.

Just another thought.

Rezarf <><
 
One thing not to over look is excessively tight shackle bolts/nuts. If there is way too much pressure on the shackle, they will hesitate "swinging" when they hit a bump.

Just another thought.

Rezarf <><

ya, shock lengths too, but I recall the shocks being alright for stock shock mounts.
 
I have ridden in a truck once with the Ironman springs, and like you said they were incredibly stiff and bouncy.

Flex the truck out in one direction, let it sit for a couple hours, switch directions, let it sit again.

Doing this a few times will definatly help, as well as removing the bottom leaf or two.

Woody's suggestion.....:)
springs 003.webp
 
talk about itty bitty baby ramps..get some real man ramps for this (another 1-2" of height)


Jeez, this isn't turning into a "my ramp is bigger than your ramp" kinda deal.....is it?:D

Ed:beer:
 
Like I said, my Ironman front springs are 6 or 7 years old. I looked at my front shackles today and they are almost verticle, just barely on the "good side". I don't think the ramp method will make a big difference. Maybe they should be called Ironbutt springs.
 
Back
Top Bottom