Builds Project ... "killer Piggy"

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

And it’s cut at an angle on the end to set the geometry of the Heim. Interesting. I was thinking originally that it looked like it needed to be flipped so that the set-screw pushed against the flat of the shaft, but now not sure. Not sure if that would change that Heim geometry for the better or worse.🤔
 
Just an FYI RUSH, the block has yet to be put into position, and yes I agree that the assumption would be to place the set screw at the flat face of the shaft ... lets see where it ends up

New rear end pic with exhaust

72651385431__29524DB1-A524-4D33-BAF5-764262172878 by Steve Heck, on Flickr
 
Ahhhhh….! That is going to look killer! I agree, paint sample on the left. If it were going to be the traditional two-tone, I would choose the one on the right.
The cement gray and black will be a good looking contrast.
 
Some updates Gents

Almost everything is done on the chassis, waiting on body now

IMG_1891 by Steve Heck, on Flickr


Speaking of ... time to select a colour

Here are my top 3 choices at this time ... thoughts ??


IMG_2063 by Steve Heck, on Flickr
Middle color.
I would be hesitant to shoot the roof panel in black, but that's already been covered...
 

Users who are viewing this thread

Back
Top Bottom