Power Steering coolers

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Mar 27, 2003
Threads
359
Messages
6,458
Location
Georgia Tech
What's better, a plate and fin type (like radiator and ATF coolers) or a tube type with fins.

I assumed the former would be better so I picked one up today, but then I wondered if there is a reason all marketed power steering coolers are the tube type, other than they are less expensive and offer enough cooling for most setups.

The two different styles are on this page, I have the lower one.

http://www.haydenauto.com/transoilcoolers.htm

My power steering has always run too hot, trying to get the temps down.
 
if it boils, it's too hot, but i'm with tj...what's your method for determining?

i put one on cause it seemed like my pump was failing fast, just a cheapy one, but i figure it's better than nothing
 
I know it runs much hotter than every other power steering system I have ever seen.

I do believe the reman pump I have may not be good, and the small pulley I run may contribute to the temps...

AFAIK cooler power steering fluid is always better (obviously to a point), unlike engine oil and transmission fluid, so more cooling capacity is better, hence the reason I asked the question.

So regardless of whether or not a new pump and larger pulley help (both of which are on the way) , I still would like to have the best cooler I can install within reason and budget.

The only reason I could see a fin and plate style cooler not being the best would be in the flow department... but for all I know it flows just as much fluid as the other, simpler style.

Thanks.
 
Last edited:
CruisinGA said:
I know it runs much hotter than every other power steering system I have ever seen.

I do believe the reman pump I have may not be good, and the small pulley I run may contribute to the temps...

AFAIK cooler power steering fluid is always better (obviously to a point), unlike engine oil and transmission fluid, so more cooling capacity is better, hence the reason I asked the question.

So regardless of whether or not a new pump and larger pulley help (both of which are on the way) , I still would like to have the best cooler I can install within reason and budget.

The only reason I could see a fin and plate style cooler not being the best would be in the flow department... but for all I know it flows just as much fluid as the other, simpler style.

Thanks.
I use a Setrab cooler and feel they are about the best you can buy.
Setrab 01.webp
 
Would factory PS, under any circumstances, ever require a cooler if you were not running large tyres?
 
Toyo FJ40 said:
The factory Power Steering had a cooler. A long steel tube that looped under the radiator on the steering box return line.


Kevin

Thanks Kevin:) Who woulda thunk it!
 
Any cooler will work so as long as you don't get the kind that restrict flow. Another words the cooler should have the same diameter tubing as the in/out of a ps pump. On the 79 factory set up they had to different size diameters and found that it is better to have the same for the pressure side and the return line as found in the newer model. The 4x4 pickups of the same vintage had the same change done to them.
 
Back
Top Bottom