Bodean
Hot Damn
Wait, what?
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
Anal beads.....my wife would stangle me with those.
Bodean
Hot Damn
I wouldnt be asking her. She wouldnt stop when i tapped out.
- Thread starter
- #205
New 16 CFM Quincy air compressor.
Overkill, but I'll never have to buy an air compressor again.
Overkill, but I'll never have to buy an air compressor again.
- Thread starter
- #207
Old rear sill is out; it was rotten. New sill is currently being fitted.
Last edited:
- Thread starter
- #208
Tacking it in. It's slow going...
- Thread starter
- #209
The rear sill is in!
- Thread starter
- #210
Fitting the PS rear quarter panel! Feels like I am starting to make some real progress now.
looking good andrew!
***PSA, careful with the grinder shavings floating around on the 200 and any other vehicle there....i had them get dampened by light rain/mist and morning dew before and rust on the paint, unreal how bad they fuct up my F150 and FJ cruiser........although it wouldn't be very noticeable on the amazon green hoe.....***
***PSA, careful with the grinder shavings floating around on the 200 and any other vehicle there....i had them get dampened by light rain/mist and morning dew before and rust on the paint, unreal how bad they fuct up my F150 and FJ cruiser........although it wouldn't be very noticeable on the amazon green hoe.....***
- Thread starter
- #212
- Thread starter
- #213
Retained factory bolt locations
- Thread starter
- #214
Tacking the quarter panel!!!
i think 49tire found a fabricator
- Thread starter
- #217
Can't afford him or anybody else for that matter.
- Thread starter
- #219
- Thread starter
- #220