Leaky Gas tank advice...

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Sep 12, 2005
Threads
59
Messages
259
Website
www.geocities.com
Hello,

I've just noticed a leak in my gas tank, it's not too bad, but definitly trouble. It is leaking on the filler side of the tank, on the bottom, where it connects together.

If I drain the tank, can it be welded or soldered back togher?

should I just buy a new tank? They seem to be hard to get a hold of, I have a 1970 FJ40.

Thanks for any help...
 
65-fj45 said:
Drain it and take it to a radiator shop. they can boil it out and then weld it. I had this done to mine.

x2

also consider have it lined (for future rust prevention - which you might have anyway) as well when you get that done.
 
Buy a new one from CruiserDan for about $240 bucks or you can use a Por15 fuel tank liner kit. I put the Por15 kit in my leaky tank last year and I'm very happy with it but it is time consuming. If you don't want a hassle just contact cruiserdan!
 
Leaky Fuel tank

Personally, I would purchase a Fuel tank repair kit from POR-15 (www.por15.com/). When completed, you fuel tank will have an impervious liner that is bonded to the inside of the tank including what rust is left after flushing with their primer. If the tank is solid enough to weld, it is ideal for one of these kits. You can do it all yourself right there in the driveway. I've found that many muffler shops will not touch a used tank regardless of how it has been cleaned.
 
Get the gas tank boiled at a raidator shop have em weld it and then got to your local motorcycle shop and purchase the Krean (sp) gas tank repair kit. It lines you gas tank with a protective coat.

I did a 1973 motorcycle XR 80 gas tank with it and in 1987 and it's still not leaking. I didn't even weld it or clean the tank---just used the kit.

Good luck,

UNO
 
65-fj45 said:
Drain it and take it to a radiator shop. they can boil it out and then weld it. I had this done to mine.

X4

My radiator guy boiled it out, brazed up the leaks, lined it with sealer, pressure tested it and painted it for $50 in one day. That was a while ago, but I bet it is still under $100.
 
Pin_Head said:
X4

My radiator guy boiled it out, brazed up the leaks, lined it with sealer, pressure tested it and painted it for $50 in one day. That was a while ago, but I bet it is still under $100.

agreed... anymore (and I did it just recently for $125) it seems more hassel and time then to pay someone else to line it and deal wth it. some of those do-it-yourself kits are just as expensive (if you do it right with special cleaners first and liners second), if not more so, than a radi shop to acid wash/boil and line for you (and prime)... plus, as important, they are on the hook if it is not done right AND they have to deal with disposing of the toxic crap that results from a home kit. it is some nasty toxic stew, and I am sure most people dump it down the gutter as what else would you do with it?
 
Back
Top Bottom