Intermittent code 26

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Ran most of the above tests. Thanks @GeoRoss and today I even tried another set of NTK sensors just to rule them out. Still no luck. I'm going to be taking it in (first time I've ever had to throw in the towel) this week. Hoping that it will be a quick diagnosis and then I'll do the repairs myself.
 
@916rockcrusher Took my truck to mike at BMR today. He's hoping to have it diagnosed by Monday. He was very cool. thanks for the referral.
 
The out come of this saga aught to good. :popcorn:
 
The out come of this saga aught to good. :popcorn:

Tell me about it!!!

It's been more of a saga then the Twilight movies. Hoping he find the problem soon and that it's not a huge fix.
 
So the saga continues. Taking the cruiser in was a hard thing for me to do. Only my second time being defeated by a vehicle. The one thing you have going for you cost wise is that electrical parts are much cheaper than drivetrain parts. Got my fingers crossed for ya.
 
So the saga continues. Taking the cruiser in was a hard thing for me to do. Only my second time being defeated by a vehicle. The one thing you have going for you cost wise is that electrical parts are much cheaper than drivetrain parts. Got my fingers crossed for ya.


This is true! I'm just hoping it doesn't take Mike long to find the issue, and that it won't cost me an arm and a leg replacing the part(s)
 
This is true! I'm just hoping it doesn't take Mike long to find the issue, and that it won't cost me an arm and a leg replacing the part(s)
Yeah I here you because if you are like me, your Cruiser already has you down to one arm and one leg. :eek:
 
He's pretty quick and from the symptoms you described it sounds like wiring. Hopefully not parts. He adjusted my AFM but I need a new one. AFMs are scarce and stupid expensive. If a bunch of us could pull together and either find someone to rebuild them or make a good MAF conversion it would be a money maker and help out everyone with AFM equipped Toyotas. Everyone with Supras to FJs has the same issue right now. A1 Crdone is the only company I've found who rebuilds factory meters. From research and talking to mechanics, Mike included they don't come back in spec from Cardone.
 
Just throwing this out there:

On my 94 I had a very intermittent code 26 that would only pop up while driving on the hwy. No noticeable change in the drivability. Long story short it turned out being the engine coolant temp sensor. The ECU would think the engine was cold and dump extra fuel.
 
Yeah I here you because if you are like me, your Cruiser already has you down to one arm and one leg. :eek:
yeah I cant lose anymore limbs!!!!

Any progress?

no news yet:( dont know if that's a good or bad sign.

Just throwing this out there:

On my 94 I had a very intermittent code 26 that would only pop up while driving on the hwy. No noticeable change in the drivability. Long story short it turned out being the engine coolant temp sensor. The ECU would think the engine was cold and dump extra fuel.

i did swap in a different ECT and it didnt do anything different. I did test my factory sensor via FSM and it was in spec.
 
just means he hasn't got to it yet. He diagnosed mine in a couple hours and it was worst case.

So I just got off the phone with Mike.
Hasn't found the issue as of yet. Said my compression is getting low, but it's. it the issue, ran a chemicals test for HG failure and it passed no problem, last thing he keeps getting is a bank 2 malfunction on the o2. He's going to replace it with a Toyota branded sensor and run the test again. Hoping this is it! Otherwise I'm going to non op this bitch and possibly replace the motor.

Did you change the coolant temp sensor for gauge or for computer?

For the computer.
 
Bummer :( I've seen a few of these engines apart with over 200k miles and the factory hone marks were still in the cylinders. I wonder where the loss of compression could be coming from, so weird. How many miles do you have on it? I buy parts from a guy in sac that sells complete lowish mile motors for $1200.
 
Bummer :( I've seen a few of these engines apart with over 200k miles and the factory hone marks were still in the cylinders. I wonder where the loss of compression could be coming from, so weird. How many miles do you have on it? I buy parts from a guy in sac that sells complete lowish mile motors for $1200.

Yeah it does! Just wanting to get it smogged so I'll have the next 2 years to get a new motor lined up.
I have 326,xxx miles on it. Runs and drives great though. Who is it that sells the motors? Is it Alex off elkhorn in north highlands?
 
Back
Top Bottom