AWD and Fuel Efficiency

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jun 25, 2010
Threads
43
Messages
199
Location
W. PA
Well, I took the family in my '91 to Tennessee and back this Easter weekend; that brings the ticker up to 427500 miles. My front drive shaft needs new U joints, so it was kind of noisy on the way down (read unhappy wife). It is fine at low speed, so I hadn't done anything about it. But above 60, it vibrates. I got 16.2 mpg while on pure interstate. I get about 12 in town and 14 in the country.
Anyway, the noise was too much for my wife. So While in Tennessee, I pulled off the front drive shaft, threw it in the back, and ran with the transfer case locked all the way back home to Pennsylvania. She looked at the drive shaft in the back and said, "It will GO without that? Isn't the drive shaft kind of important?" That gave me the opportunity to wax eloquent about what a spectalcular vehicle the FJ80 is. "It's got two driveshafts, and so long as either one of them works, it's good..."
I read not too long back some discussions about economy on 2 versus 4 wheel drive (although it's technically only on 1), I'll say that unlike some who have posted here, I could not notice any difference between all-wheel and rear-wheel drive in city or highway handling whatsoever. No hood lifting, etc.. I didn't floor it, but drive pretty conservatively. My highway mileage with 2-wheel drive: 16.2 mpg. Absolutely no benefit at all. So my recommendation is not to bother trying to downgrade for fuel's sake.
 
" no hood lifting"....dude, the only way to lift the hood on your '91 is to get read ended by my '96.......your '91 got no balls to begin with. :flipoff2:
 
:D the hood lifting comment was made by somebody when it was suggested they disable the front shaft to get better mileage. I agree, there's no way an 80, (and especially a 3FE) will ever wheelie.
As for skintunes comments, all is well. Drove 700 miles with only a rear shaft and center diff locked. Until I get my new spiders in, I'll keep on turning over the miles.
 
Haven't the people who have gone to the trouble of converting to part-time hubs in the front stated that they saw little or no difference in mpg?

Certainly not enough to justify the labor and expense. Less than they could have seen by airing up their tires a little more.
 
Haven't the people who have gone to the trouble of converting to part-time hubs in the front stated that they saw little or no difference in mpg?

Certainly not enough to justify the labor and expense. Less than they could have seen by airing up their tires a little more.

It only helps if you have a snorkel.:meh:
 
Well, I took the family in my '91 to Tennessee and back this Easter weekend; that brings the ticker up to 427500 miles. My front drive shaft needs new U joints, so it was kind of noisy on the way down (read unhappy wife). It is fine at low speed, so I hadn't done anything about it. But above 60, it vibrates. I got 16.2 mpg while on pure interstate. I get about 12 in town and 14 in the country.
Anyway, the noise was too much for my wife. So While in Tennessee, I pulled off the front drive shaft, threw it in the back, and ran with the transfer case locked all the way back home to Pennsylvania. She looked at the drive shaft in the back and said, "It will GO without that? Isn't the drive shaft kind of important?" That gave me the opportunity to wax eloquent about what a spectalcular vehicle the FJ80 is. "It's got two driveshafts, and so long as either one of them works, it's good..."
I read not too long back some discussions about economy on 2 versus 4 wheel drive (although it's technically only on 1), I'll say that unlike some who have posted here, I could not notice any difference between all-wheel and rear-wheel drive in city or highway handling whatsoever. No hood lifting, etc.. I didn't floor it, but drive pretty conservatively. My highway mileage with 2-wheel drive: 16.2 mpg. Absolutely no benefit at all. So my recommendation is not to bother trying to downgrade for fuel's sake.

Congrats on your ability to do that, remove the drive shaft and keep on trucking. I wouldn't have even known that was possible. Impressive and 472,XXX miles, Wow! I hope to get to that point with my LX down the road. Cheers.
 
Thanks! 427K but still, I'm smelling half a mill. Got some grinding to do living in PA, but the underbody's good. Drives like a champ.

Congrats on your ability to do that, remove the drive shaft and keep on trucking. I wouldn't have even known that was possible. Impressive and 472,XXX miles, Wow! I hope to get to that point with my LX down the road. Cheers.
 
Well, I took the family in my '91 to Tennessee and back this Easter weekend; that brings the ticker up to 427500 miles. My front drive shaft needs new U joints, so it was kind of noisy on the way down (read unhappy wife). It is fine at low speed, so I hadn't done anything about it. But above 60, it vibrates. I got 16.2 mpg while on pure interstate. I get about 12 in town and 14 in the country.
Anyway, the noise was too much for my wife. So While in Tennessee, I pulled off the front drive shaft, threw it in the back, and ran with the transfer case locked all the way back home to Pennsylvania. She looked at the drive shaft in the back and said, "It will GO without that? Isn't the drive shaft kind of important?" That gave me the opportunity to wax eloquent about what a spectalcular vehicle the FJ80 is. "It's got two driveshafts, and so long as either one of them works, it's good..."
I read not too long back some discussions about economy on 2 versus 4 wheel drive (although it's technically only on 1), I'll say that unlike some who have posted here, I could not notice any difference between all-wheel and rear-wheel drive in city or highway handling whatsoever. No hood lifting, etc.. I didn't floor it, but drive pretty conservatively. My highway mileage with 2-wheel drive: 16.2 mpg. Absolutely no benefit at all. So my recommendation is not to bother trying to downgrade for fuel's sake.
 
Hello I'm new. We made a trip this past Friday from Broken Now OK up to the City. U joints noisy so today we pulled the FDS and locked diff using the fuse method. Reading this tells me that it's safe to drive back home today... 200+ miles and it will be safe. Yes? We will do the repairs and maintenance, but we need to go home right now. So that's ok? Thank you.
 
Hello I'm new. We made a trip this past Friday from Broken Now OK up to the City. U joints noisy so today we pulled the FDS and locked diff using the fuse method. Reading this tells me that it's safe to drive back home today... 200+ miles and it will be safe. Yes? We will do the repairs and maintenance, but we need to go home right now. So that's ok? Thank you.

You can leave it like that as long as you want. One of my rigs has had the front driveshaft out for 2-3 years now.

Welcome,

Curtis
 
Just don't experiment with unlocking the center diff for any real distance. If you have a truck with a viscous coupler (93+) it'll move with the CDL disengaged but feel like the transmission is slipping. This is the viscous coupler trying desperately to match the front and rear driveline speeds.

Other than that, no, it doesn't hurt it at all.
 
Ditto: you can drive as long as you want with one driveshaft out with the CDL is locked.
 
Back
Top Bottom