Advancing the odometer-- How?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

baldilocks

Battle Ground, WA
GOLD Star
Joined
Jan 29, 2014
Threads
212
Messages
10,141
Location
Battle Ground
I want to swap in the gauge cluster from my rolled 94 to my White Rhino because everything from the deceased is much nicer.

The current reading is 274 the unit I want to swap in reads 266. I realize that I can simply add 8k but this question begs an answer. Spare me the Ferris Bueler comments.

Is it possible to advance an 80 series odometer manually?
 
There is no cable.
 
giphy.gif


Honestly I would just add a sticker somewhere. The chassis, transmission,brakes, steering etc still has the 274, plus if you were to ever sell it the potential buyer might be turned off by the whole rolling back the odometer or it even being touched. I would be.
 
giphy.gif


Honestly I would just add a sticker somewhere. The chassis, transmission,brakes, steering etc still has the 274, plus if you were to ever sell it the potential buyer might be turned off by the whole rolling back the odometer or it even being touched. I would be.
READ advance
 
Ok, I see what what happened there....:doh::flush:

:beer::beer::beer:
 
Wires to an out put unit.
 
IMG_5209.webp
 
Pull the output unit, and spin it with a drill?

It's still a mechanical odometer though?

I've previously opened up a GM dash cluster to change the odometer reading (same reasons) I was able to gently pry the wheels apart slightly, and rotate them one at a time without shifting the wheel either side.
Fairly high stakes though, it's easy to fxxx something up and be looking for a new cluster.
 
How many revolutions would the output need to do to make up your 8k miles?
You could calculate how many minutes (or hours?? ) you'd have to spend with the drill of your choice to get your 8k back.
 
I adjusted the odometer on an EK ('96-'00) Honda Civic cluster years ago for similar reasons. I can't say if the 80 series cluster is the same, but I was able to rotate the dials by prying back the tiny plastic fingers that act on the gears with flat toothpics, it's very fragile, very tedious, and very easy to end up with a cluster where the numbers don't line up straight when you're done.
 
I realize that there is a plastic gear inside the transfer case which is driven to generate a signal but from there on it's purely electrical.

I was hoping that it could be done simply and low risk of damage by opening up the cluster and spinning the individual numbers But it sounds like that might not be a good idea.
 
Honestly, 8k on a 264k unit, most odometers are off by more than that due to oversized tires and uncorrected gearing. I would swap and roll on
 
Last edited:
Honestly, 8k on a 264k unit, most odometers are off by more than that due to oversized tires and I corrected gearing. I would swap and roll on
Doing this could cause me to break out in a rash or worse! :eek:
 
Honestly, 8k on a 264k unit, most odometers are off by more than that due to oversized tires and I corrected gearing. I would swap and roll on

This.

They are designed to be tamper resistant, not intended to be messed with.
 
Back
Top Bottom