$350 for seal replacement

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Aug 3, 2006
Threads
211
Messages
3,658
Location
Madison, NC
I just got a estimate for replacing the driver side inner axle seal because its leaking diff. fluid into the hubs. I've done most of the work so far on it so I thought about doing this myself but dont know if I have the know how to do it. Is this project to big for someone with limited knowledge, and is $350 to much to pay if I have a shop do it? Thanks.
 
do it yourself, the best way to learn. not as ahrd as you think, just put things back together the way you took them apart
 
$350 sounds about right for an estimate

$20 parts 4 hrs labor @ $80hr.


camcruiser13 said:
do it yourself, the best way to learn. not as hard as you think, just put things back together the way you took them apart

2x

get the fsm and do a search.


While you are there, you may consider checking/ replacing:

Knucle seals
brakes
wheel bearings

All new parts would cost less than the quote and thats for BOTH sides.

this is a very complete rebuild kit (includes ALL seals, bearings etc)

http://www.tpi4x4.com/05-lcKnuckleKits.html



It is a messy job, but no too difficult to accomplish. (see post #63)
https://forum.ih8mud.com/showthread.php?t=45844&page=2&highlight=pair+fjs
 
Last edited:
It's just messy and takes time.
 
Just a couple suggestions for you in the event that you decide to take this on yourself.


Purchase a few extra seals, not just the inner axle seal, but wheel-bearing seals also, as damaging one of these is not uncommon for someone that is installing a seal for the first time. Having a couple spare seals is not a bad thing, but rather, cheap insurance.

Clean, inspect and repack the wheel bearings, and yes, replace the wheel bearing seal.


Pick up a Factory Service Manual if you do not already own one, they are great reference material, and keep the keyboard from getting covered in grease. ;)


Have fun!

Good luck!


-Steve
 
My one tip is to use Toliet paper to clean everything up... Poo and grease are about the same... and tp is cheap.

Have fun, get messy up to your eye balls. Like everyone has said it is messy not hard.

Rezarf <>,
 
hendo said:
... if you never try it then how are you going to repair a broken birf on the trail ...

Prolly the best incentive stated yet!
 
REZARF said:
My one tip is to use Toliet paper to clean everything up... Poo and grease are about the same... and tp is cheap.


Rezarf <>,

dude, if your poo looks like axle grease you gotta go get your sh*t checked by the doc, :), couldn't resist, sorry.

Noah
 
1973Guppie said:
dude, if your poo looks like axle grease you gotta go get your sh*t checked by the doc, :), couldn't resist, sorry.

Noah


LOL! Yeah, if your dookie looks like moly grease then you have more serious problems than a leaky seal!

:D

Rezarf <><
 
Back
Top Bottom