vibration

  1. 9

    Potential cause of rattling? Image posted

    i have a 94’ fzj80 with a 4 inch ome lift on 315/75r16’s. Lately I’ve had a bad rattling noise that didnt sound like my exhaust rattle. Looked under the truck to find the bushing on the stabilizer bar completely missing on passenger side and falling apart on driver side. Any idea on part numbers...
  2. Str8Razor

    97 LX450 Flashing Check Engine Light/ Vibration

    Truck has 195k miles on it and s***ty valve seals, Left for work this morning, accelerating through the gears and all of a sudden i get a heavy vibration and the check engine light starts to flash, truck was not happy and vibrating considerably over 2100 rpm, seemed to go away or calm down a bit...
  3. C

    Vibration at highway speeds

    Hello all. I recently have been experiencing a pretty bad vibration in my 85 FJ60 at 55mph+. It will do it all above speeds above 55 mph (I've only been brave enough to take it up to 70) both while accelerating, coasting, engine braking, and in neutral. The shaking feels like its coming from...
  4. CloudCity

    Possible cause of door "speaker" buzz or rattle

    I had my rear door panels off again last night to refoam my speakers since I had the wrong size kit last time I went in and could therefore only do the fronts. What was odd was one of my front doors that did have the correct sized foam recently installed was also buzzing when there was a...
  5. AaKnight

    Does this Pinion Flange look right to you?

    I admit I don't know much about differentials, and I'm chasing down a Driveline vibration. Was hoping someone more knowledgeable could watch the and tell me if this is where my problem is, or if this appears normal. symptoms are growling on deceleration, almost like a lawn mower. After the...
  6. YoungStingy

    Master brake cylinder going bad? And vibration in Overdrive..

    Hello fellow 100 series owners, Had my lc100 ‘01 for a little over a year now. Put 20k on it since purchase. Put a lot of monet in it fixing it up. I’m nearing a cross roads in what to do. Ever since I’ve owned it, I notice the MBC shakes briefly occasionally. I assume it’s the factory...
  7. Tonto18

    Vibration/Shudder @ 1750 rpms; lurch going from stop into first

    89 FJ62 automatic. When accelerating in first, have strong vibration/shudder at about 1750-1800 rpms. Whole truck and especially the steering column shakes, then smooths out after about 1800. No other gears do this. Also, when at a stop, when transmission drops into first there's a bit of...
  8. Bill F

    Chasing a weird vibration...

    Hi Everyone, have a new question for the MUD hive mind after having searched around to no avail... I'm having a weird driveline vibration, best described as a 'buzz' at freeway speed, here are the symptoms: - Happens only when the Cruiser is warm: When cold (at low and freeway speed), it is...
  9. A

    Weird pedal vibrations and uneven ride heights?

    Hi guys. This is my first technical post so far, so please go easy if I miss any details and tell me to provide if needed. I have just bought a 2017 Land Cruiser 200 4.6L V8 Petrol 6 speeds atomatic (UAE imported) which has only reached around 1000 Miles now, have the engine oil changed and...
  10. I

    Vibration at 55-65 when accelerating after new CVs

    So i have been searching on here and all over the web but i am not seeing the same issues... Anyways about a month ago i took my 2006 LC in to get the CVs and axles replaced because the boots were cracking and it wasn't much more than just replacing the boots. I usually do this stuff myself...
  11. R

    Vibration issues with my BJ 73

    Hi all, Looking for some advice on identifying bad vibrations in my Bj 73 wagon. So i recently had my exhaust repaired as it was rattling and came away from the flange mount. Had a flexi fitted and also a bracket to support the pipe on the engine. Pretty happy with the results although the...
  12. roryhamaker

    FZJ80 Lift Questions

    Guys, i have been fighting with my 80 ever since i put the lift on, for reference i used the OME 2". I had a bad vibration and humming noise coming from under the truck from about 30mph+. I did some research here and found most people were suggesting the OME front control arm bushing offset...
  13. riffman12

    new tires - now getting a pulsing vibration on freeway

    I recently had 285/75/16 Falken Wildpeak AT3Ws mounted on my '97 At about 65+ mph I'm getting a strange vibration. It happens about every second. Like a low hum that pulses. hummmm...hummmmm...hummm nowhere near as quickly as a tire or driveshaft spinning at 65mph. I'm not feeling it through...
  14. vanqu1sh

    Front passenger vibration

    My 1999 LX470 has had a slight vibration coming from the front passenger wheel area since I purchased the vehicle a year ago. Since then it's steadily gotten worse. The vibration only occurs when accelerating. Coasting or braking at any speed is fine, but as soon as I accelerate I feel the...
  15. Javelin

    Vibration After Installing Slee Skid Plates

    I installed my full set of steel skids from slee last night. I noticed that the truck has a slight vibration now. I checked all the bolts and everything is tight. I am wondering if it's the exhaust pipe. It comes very close to the belly pan like 1cm or less. No rattles or squeaks just doesn't...
  16. T

    13 bt vibration

    My BJ71 with 200,000km has developed a vibration at 1300 rpms. Lower or higher rpms it goes away it is only at this rpm. Does it in neutral or when it is in gear moving into a parking spot and rpms fall it will do it when it passes thru that rpm range thanks for any help i am new to the forum
  17. ccasteel

    Droning & Vibration investigation

    My '99 LX470 has recently started droning like it's on a grooved highway. It's a low drone when headed straight, but a slight turn to the right and it gets noticeably louder. (left turns yield not much change from straight) The vibration is felt mostly in my feet and seat. Not so much in the...
  18. T

    Vibration grinding sound after 3-inch OME lift--drop transfer case????

    1997 Land Cruiser I just installed the 3-inch HD OME lift. Looks great and feels smooth but I have a grinding sound/vibration at high speeds (65mph+) and especially audible when I release the gas from high speeds. I initially thought driveline angle issue after lifting it but would a 3-inch...
  19. B

    2002 LC Vibration between 3-4k rpm on accel?

    I have a 2 2002 Lc's one is perfect and the other I been getting a vibration between 3-4k rpm soon as i hit 3k it starts and once above 4k it goes away. it seems to be doing it in 3rd gear. I checked the front and rear drive shafts, they are tight. I did a lock to lock while driving forward and...
  20. lumbee1

    Diagnose my Cruiser

    I've got several issues with the Cruiser that I need some advice/assistance with. After swapping the U-joints out last week, I've noticed the truck isn't running as smoothly. When I dropped the driveshaft, I marked everything with Whiteout to make sure I put it back in the same way. U-joints...
Top Bottom