series

Hello, Unlike most folks, I really like my factory swing out. Unfortunately I had a good smack on the tire while the car was being worked on elsewhere. It looks like I will need the following to get things repaired: -exterior swing out parts; arm and both QP mounts (pretty sure this is one...

Sold the 80 so no longer need. Comes with a Curt ball mount but no hardware. $100 Pickup only. Located in San Carlos

Selling parts from a 80 series project that I picked up along the way. See exhibit for part # and suggested price, buyer pays shipping. PM if interested. Quickest way to reach me is to text 704-200-8768 -Todd other items not listed: 2nd row seats, 3rd brake light, rear bumper, rear slider...

Thanks for the help!

I'm looking for 80 series frt and rear OEM Locker 3rd members. Gears are unimportant (cores) but lockers must be good. Also would be interested in a non locked 80 frt 3rd as well. Colorado springs .

Fishing around before I bite the bullet and buy one retail.

tried to start today and only clicks. Charged both batteries and load tested them all good. it uses 24 volts to start. checked starter relay all good. Replaced 12 - 24 change over relay as was getting bad resistance across 1 contact. Has anyone had this problem before?

Fully plug and play for an 80 series with planted brackets, OEM seatbelt buckles and wiring for dash light. Seat belt buckle slides with the seat. Both seats have heaters but I'm not aware of what wiring would be needed to get working. I also believe that the passenger seat has occupancy...

Brand New. Complete. I ordered this planning to install it on my LX, which can be done with some modification to the fender mount. However, since then the company released an LX specific version. So I'm selling the LC one and ordering that one. $550 shipped in the US. The cheapest you will...

I've been removing some aftermarket antenna stuff (am/fm and uhf cb) from my 80 today and got curious about the vacuum setup that is used with the brake booster (no clutch booster on Oz 80's). I've never seen any sort of warning light show up or any sort of buzzer making a noise, so I'm not...

Toyota Land Cruiser 60 Series Rock Sliders. Great shape overall. Previous owner had them coated in bedliner. Shipping can be accommodated at buyer's expense. You will need to source some new mounting brackets as the originals are welded to my frame rails. These appear to be from: 4PlusProducts |...

I'm looking for a picture, if possible, of one of the PTO drive shaft pillow block brackets from a late 60 Series. There seem to be multiple arrangements of drive shafts and brackets. I'm not sure when the change occurred, probably late 87 with the facelift, but I have seen an early (1984ish)...

Looking for a driver side quarter panel fender flare.

80 series gas pedal. $20 + shipping

2 rear Brown seatbelts $375. NOS in box. Never used

$110 shipped

ok , so what is the real world technical opinions of the 2024 re-released 70 series , this fresh mini-pod-cast seams objective ? your thoughts and opinions please thanks matt

Selling this radio removed from a 96 80 series. Can't tell you how good it works but take a chance on it for $35. Buyer pays shipping. Best to email me shmukter@pa.metrocast.net

Selling this engine control module taken from a running 96 80 series. Price $45 plus the ride. Best to email me shmukter@pa.metrocast.net

Here's a real nice gray shifter console from a 96 80 series it has had two 12V lighter type receptacles very cleanly installed. $45 plus the ride best to email me shmukter@pa.metrocast.net