Hi all,
I am considering replacing my 1994 GCC spec H151f with a H152f. Looking to see if anyone would be interested in buying my H151f after it’s removed. My transmission comes from a GCC spec FZJ80 1FZ-F truck that sat in a royal garage for 25 years before I became second owner. Has 150K kms...
Looking for the August 1980 Body & Chassis factory service manual that covers 4x and 6x vehicles. See the photo below (ripped from an old eBay ad). Decent shape preferred. No photo copies, original only.
Hi all. Long time user of the wealth of information available on this site with the various Land Cruisers owned over the years! I have finally got my hands on a 1988 HJ60 5 speed manual, my dream Landcruiser that has the low roof and GX model (mainly preferred interior and low roof over the high...
Hey all, I bought an 1997 hdj80 with h151 to swap my 3fe and auto trans out my 1992 jdm cruiser.
My question is I have seen where the part numbers for 91-92 are different of that of the 93+. Can the 97 pedal set work in the 92? Or do I have to source a 92 pedal set?
Regards
Dan
How's it going,
I'm looking for the trim cover that goes over the driver and passenger seat hinge and pull lever on a set of manual 80 series seats. I'm missing these covers in my truck.
I've looked at a few diagrams and think I've found the correct part but it might be superceded? Any...
Gday, been chasing a factory service manual for the 1HDFT engine, publication RM437E. I know there’s a PDF version of this book, but I’d definitely like to get my hands on a hard copy. I’ve heard they’ve been discontinued, so is seeming like it’s a needle in a haystack type of situation. Anyone...
I've got an 1993 Lj78 with that a343f that needs rebuilding/replacing, torque converter also probably needs replacing/rebuilding. Prado/landcruiser a343f are incredibly hard to find here in Ireland and I would estimate a rebuild of the box would cost me €2k excluding the torque converter. With...
HAPPY NEW YEAR! So, I was hoping the kind folks on here could maybe help shed some light on what hardware my 1988 4runner currently has.
I was poking around under my 4runner, cause why not, and noticed I have the chain driven t-case (I believe) vs the desired gear driven. I can see I have...
I have a 2004 manual 105 series Land Cruiser Standard with part time 4WD (from factory). I recently replaced the clutch and since then when I put the car in 4WD, no lights come up on the cluster like they previously used to - to indicate that the vehicle is in 4WD - the car still mechanically...
Looking for either the two front seats or a full set. Thanks!
Due to the high cost of shipping, would be looking to pick up somewhere in the SE. I drive through FL, GA, SC, NC, and TN regularly.
Anyone have the link of the AHC sensor programming? Not the manual adjustment to the physical sensor but digitally adjust the sensors and get readings via tech stream.
looking for a procedure doc or a thread I can follow and print out. Thanks.
I've started to have some issues on some of the higher elevation passes here in Colorado. Had an issue up Berthoud Pass yesterday which is a 6.3% grade at its steepest point. When I get around 2.5k RPM in any gear it will start to stutter and blow some dark grey and black smoke. I cannot get it...
Greetings fellow awesome people, I live in California. However my wife is in Colombia and I made the decision to buy a 1994 Toyota Land cruiser 80 Series there. “Burbuja” (Bubble) as they refer to it for it’s round shape and what would happen to you in the 90s if you touched one considering the...