fj62

3fe engine, transmission, and transfer case from 1989 FJ62. 200,000 miles. It ran and shifted fine when I took it out. Just wanted something else. The vacuum actuator on the transfer case did break while being taken out. $1,250.00

Now offered at $34,500 or best offer, this 1991 Toyota Land Cruiser FJ62 is powered by a 1FZ inline-six mated to a H151F five-speed manual transmission and a two-speed transfer case. The truck is finished in gray and features quad rectangular headlights, chrome bumpers with black end caps, a...

Symptoms: Blinker’s intermittently work correctly Occasionally, when turn on, instead of blinking, the turn signal stays on. Same with the hazard lights… when they work, they work properly, when they don’t, they either just stay lit or don’t turn on at all. Assuming that I just need to replace...

Description: Cylinder Lock Set W/glove box & back door locks P/N: 69005-90A64 Condition: New & OEM Fitment: FJ62 from 88’-89’ (fitment table attached) Price: $666.66 Shipping: Dhl for $34.00 Payment: PayPal

Hello! I'm looking for a FJ60/62 Land Cruiser. I'm located in North Shore MA but willing to travel a few hours. Ideally looking for something stock and daily drivable. I'm not so concerned about mileage as long as its been taken care of. Trying to find a truck that isn't totally rotted out. I'm...

The FJ62 is now my primary car, so I'm returning it back to a mostly stock exterior. Up for consideration is an ARB front bumper with Warn winch & KC lights already mounted. $1500 for the setup. Would consider keeping the winch if price flexibility is needed. Pickup north of Indianapolis...

Description: FJ62 Transmission & Transfer Tunnel Cover + Boots + Boots plates Condition: used oem in good condition Fitment: 88’-89’ Price: $175.00 Shipping: Dhl $35 Payment: PayPal

Does any one know of an aftermarket direct bolt on exhaust system from manifold back? Something similar to what OTRAMM used to produce? Looks like Toyota only sells muffler back. Mine is hanging on by a thread. I could take it to a shop but would like to install myself if possible. im also not a...

Hi all, Been looking for a Land Cruiser for awhile now searching through all the common online sites. Then one day I was walking my dogs in my neighborhood and notice an '88 Fj62 parked on the street. The owner was in his garage. I told him, "nice fj62." He said "thanks, wanna buy it?" ...and...

SOLD 3FE and mated A440. No tcase. 265,000 miles on them. Ran and drove when I purchased the vehicle ~ August 2022. Reason for selling, LS swap. Known issues: Main seals and oil pan leaks, probably valve cover too. A440 transmission struggles to shift between 2-3 gear. I tried messing with...

Figured I would check locally to see if anyone within 100 miles of Houston had any front or rear aftermarket bumpers that they either decided not to use, or pulled off. Doesn't have to be in perfect condition, and Im not too picky ( aside from Smittybuilt tube style ). I have a winch in the...

Anyone fab a tire swing-out on an OEM rear bumper of a 60 or 62? Would love to see how it could be done for a potential DIY project.

Hi All, Have a yard and a half of grey seat cloth from SMS. Took me a year to get it (they are the absolute worst, except the quality is good) and truck is now sold. LMK if you are interested, cost me $250 ish. Can send pics.

Hey guys, starting tearing down the transfer case for a rebuild, mainly due to a whine it had developed. I has eliminated front and rear diffs as possible culprits. Idler shaft was worn out just about as worse I had ever seen, luckily it and the bearings are included in the kit from cruiser...

Selling my 1989 Fj62 Land Cruiser I have owned it for about four years and have absolutely loved it. New catalytic converters Rebuilt transmission Rebuilt engine (inline 6 3fe) New brakes front and rear (rotor/calipers/bearings) Recent paint job (5k) New tires. Bf Goodrich 32” KO2s Old man...

Four rims I removed from my FJ62 recently. Cleaned them up and removed as much rust spots by hand as possible. Turned out quite nice. Would grade them at B+ overall. No chips, no dings, nothing bent. $400 for the set. Local pickup only in West Los Angeles.

I'm looking for a replacement for my Igniter & coil. Part numbers: 19070-61080 Pic attached.

When I bought my 62 a few years ago, PO had installed a nice ARB bumper/bull bar along with some lights. When I got it home, I decided to switch back to the OEM bumper. Since then, the ARB has been in storage at my house, and I think it's time to sell it. It's in great shape, no signs of any...

I have a few extra parts located in houston, tx. I am asking $150 for the fan shroud, $100 for the skid plate, and $100 for the wheel. Please see pics for condition. Feel free to ask an questions, thanks!

This is a story of the most over-complicated and annoying inconvenience I've ever had ordering car parts in my life, which at the time of writing this, is still yet to be resolved. The time is long overdue for my FJ62 to get a new radiator so naturally, I went with CSF as they are the only ones...