engine

Hey guys and gals, I'm hoping someone may have a good rebuild or low mileage 1FZ laying around sometime soon. My '94 with 208K is making a lovely lower end knock that comes on nice and noticeablely every time I get on the gas or torque load increases. As much as I'd like to pull the engine...

DM Email or phone numbers and I will send pics. Thanks. The body parts are all very clean and have minor rust 3FE Engine 260K miles-runs pretty good-Complete Engine $850.00 72 FJ40 TUB-Very Clean $1000.00 72 FJ40 Frame w/TITLE $250.00 72 FJ40 Front BIB $100 72 FJ40 Windshield Frame $200 78...

Now selling the running engines! 1PZ engine sold 150K KM 1HZ SOLD I'm (WRAPPING UP!) a body swap and a 12 volt conversion on my PZ77 from a LJ78 donor. Also going to part out a HZ 73. Have most of the 73 and 78 series availible for parts. the LJ78 only had 49,000 Kilometers on it. The 73 has...

I am looking to sell my FJ60. I had the engine rebuilt less than 5k miles ago and blew something. I have no time/money to rebuild it again for my own purposes but I've never sold a non-running car before so don't know if there is a market and if its better to just bite the bullet and get the...

Ok, I'm new and couldn't figure out how to post in the Classifieds, but I need two valve push rods for my '85 FJ60 that are destroyed. Hope someone has a few extra sitting around. Looked online and only found in quantities of 6. Anyone know were I can get 2? See: 1985 fj60 engine hard...

Any help on where to buy a new FZ engine is greatly appreciated! I am looking to exchange my actual 3F on an FJ80/1991. I'd like to see the FJ perform much better than the posible upgrades I did on the 3F, still feels heavy.

I'm weighing the options between a 350 conversion and going cheaper and doing a rebuilt 2F. I'm going for cost savings over performance, but performance is nice at the right price. I don't care about getting 10 miles per gallon. I just want my rig to run well. Any suggestions out there from...

Whats up mud! Been on here for a long time mining land cruiser information. I finally bit the bullet and bought a 94 FZJ80 locally. It was in pretty rough condition cosmetically but the body was straight, it had factory lockers, and I could get the engine to run. $2500 and new battery later and...

Just for fun. Which cruiser engine is easiest/best to work on? I have a 3FE that's working fine, but I always wonder what other engine I would throw in there if it died.

I was thinking about buying a 97 LC with lockers it has close to 400K miles on it. i was wondering if i should just stay clear of this and look for one with a lot less miles. the price is pretty low that is why i am so interested. I do not currently own a LC but wold love to get my hands on one...

hey I'm looking for a used f engine in good working order to swap mine out with. message me if you have one or know someone who does. located in Boone NC

I have some left over parts from a custom engine swap project: 3FE Engine Block was pulled running from a 220K vehicle. Only Lower Block, No Head $400 A440 Auto trans, good for core return or for rebuild. Has a clunk in it. 220K Miles $275 Both parts removed from same 1988 FJ62 Landcruiser...

Hey guys, I am new here but I am on my second FJ60m which I just bought. I was driving last night in the heavy rain and hit a deep puddle at the same time a big truck hit that puddle going the other way. The whole front of my truck was hit with a lot of water and the engine about 20 yards...

1FZ-FE , 231,524 miles 1994 $750.00 Trans and T-case also available PO states that the truck ran early in 2015 and was parked, would not start in 12/15 PM if interested

Yet another 1FZ-FE rebuild thread... hope there are a few things in here that may help someone down the road. First I want to say thanks to all of you who took time to answer my questions along the way and to those who have posted in the past. This forum is nothing short of incredible. What I...

I am new to the forum and new to the Landcruiser owner club. I recently bought an 87 fj60 with a leaking headgasket. After sending the head off to be rebuilt, I found out that it is cracked. This has caused me to shift the direction of the build completely. I know that the protocol is to...

Good morning/afternoon/evening everyone, i have 2 simple questions. Hope somebody can help me. :) I have an FJ55, the paper said it is from 1968, however the engine of this FJ55 is H-Engine (or 2H?) with engine number "H 145XX". As i browsed to the online world, ive noticed that FJ55 from this...

Hi guys, I have found a 92 70 series with a 1PZ in it with 150k miles. I"m looking for a 1FZ but those are impossible to find where I live. All 70s here are diesels. I plan on using my LC as a daily driver and some light offroading. I will add a bull bar, larger tires and a winch. Do you have...

I have not found any information about this as of yet. Does any one know if the engine from a 93 land cruiser would work in a 97. I assume that it would, and have not found anything to say it wouldn't. I would need to look at an engine from a 93 to see. Any thoughts on this? I need another...

I have a 1987 22re the motor was just rebuilt about 7k ago. Almost everything under the hood is new and even the shop that built the motor is stumped! It starts, runs, and idles just fine even drives for a short time. Then it starts a constant puttering and drops power. New distributor, plugs...