I have a 99 Land Cruiser that cranks but does not start. The issue just started last week after I tried to move my LC from the front of my house to the backyard.
Last week, I started up (cold start, well it was 70 degrees outside) drove forward and then backwards to back into my driveway. Once...
Hi all.. as part of my upgrades project this day after tomorrow I am installing my new independent Zietronix ecm system.. in addition to the factory map / egt / o2 sensors the new ecm also has additional inputs for rpm, tps, air intake temp & coolant temp..
I need an ecu pinout diagram to...
Up for sale is a 89661-60221 ECM in good working order. This is for the 93-94 1FZ-FE engine. I did an engine swap and no longer need.
Perfect spare or a replacement for failing
NLA part, so it will be worth it's weight in gold down the road.
$100 SHIPPED FREE...
I recently had the 80 partially tore apart, running coax down the passenger side, for a CB install.
As often happens when I undertake any project on the Cruiser, I end up following what I call rabbit trails; one project leads me to investigate something different, that may lead to something...
Anybody heard of a place that modifies ECU's for the 2UZ-FE engine that strips it down to the basic essential engine functions? I'm hoping for an ECU stripped of the immobilizer, emissions, and other uneccessary functions.
On my 96, I have a CEL and want to see if there are any codes. So I plugged in the OBD2 and started Torque on my phone. It just keeps trying to connect and no matter what it says it cannot communicate with the ECU (or ECM - forgot which terminology it uses).
I actually tried 3 different OBD2...
Ok, here we go... I have a 1997 FZJ80 that last year this time was a Victim of what I believe was a power surge caused by a lightning strike here in Florida. The ECM in question is part number 89661-5542. Here is the short version, I narrowed it down to a bad ECM. With help from the Service...
Wanted: A working 1994 Fzj-80 ECM computer. Let me know who has one from part out or one laying around please.
For those that have contributed to my post on the forum:
Engine stalls when braking or idle
Thanks in advance
Selling the following parts from a 1994 factory 3X locked FZJ80. Rear electrical harness including actuator vent tube, factory locker dash switch, and Toyota ECM for lockers.
SOLD for all, plus shipping. Will fit in a flat rate box.
Dash switch and ECM: