cover

Hello Forum, looking for the driver bottom seat cover in gray for Fj60. Thank you

Selling this very clean bottom inspection/access cover for Toyota foor/five speed bellhousings. I know there are two bolt patterns so check the photos to verify if this is the one you want/need. This one is very clean these are hard to find. $75 buyer pays shipping. Best to email me...

There are two SOR options for a 40 leather steering wheel cover, 16-17" and 17-18". Any reason OEM would have two different specs?

Where can I get the really small rubber plug that goes in the center of the wiper motor cover

3B Diesel engine Tappet Cover / Rocker cover To suit: BJ42, BJ43, BJ45, BJ60, BJ70, BJ73, and BJ75 https://ikaaautoparts.com/shop/ds/toyota-landcruiser-3b-diesel-tappet-cover-rocker-cover/

Selling a red 79-82 transmission cover plate that bolts to the body. Will post pictures up when I get home $75 plus shipping

Hello, While replacing the head gasket on my 1fz-fe I dropped a 8mm washer into the timing chain cover. I removed the crank position sensor and can see the washer from there. The washer is sitting at the bottom of the timing cover just forward of the crank position gear. I have been unable to...

Have a real nice mirror here not sure exactly what the electronic box and wire harness are for (box caries part number 86860-33080) but the mirror is very nice and it comes with the cover which is in great shape too. Price $42 plus the ride. Also haver the two dome lights from the same 96 80...

Looking to purchase a Ruff Stuff or BTF (Blue Torch Fab) or NitroRear Differential Cover.

Has anyone had any luck finding aftermarket roof rack covers for the larger rails for my 2003? I am currently holding mine together with silicone. I have ordered two different sets that have been too small. There must have been more than one type of roof rack installed on the 100s? Or, if...

It appears that the PO replaced the windshield frame on my 1978 FJ40 with an older frame. The rig was rolled. I have the wiper motor and the cover, but mine is wider than the holes in the frame. Will the motor for the 78 work with the older frames? The holes on the motor mounting plate line up...

Are there any companies or forum-folks who wrap OEM stock wheels with black leather? Looking to upgrade my '78 wheel as I'm making her more a daily driver. Thanks.

Need left side louvre cover . Needs to be inane with all tabs/ attachment clips. Please let me know price with shipping to upstate New York. Thank you-AD

Thought I’d share since I know lots of us have worn leather on the shifter handle. Took a gamble and ordered a replacement cover from AliExpress for ~$20. 100% satisfied with the results. Just don’t be a dummy like me and attempt to take apart the O/D switch.. just de-pin the connector under the...

Does anyone have either a template or good pictures of where the stock holes are supposed to be in the transmission cover for a 3 speed with manual transfer case? Mine had a vacuum actuated transfer case originally and someone just cut one big hole in the cover. I would like to weld up the...

As titled. I’d rate the powder coat job a 8/10. Really good but not show quality. $150 + shipping OBO. I can get pretty good ship quotes provided an address and some details.

Getting a timing cover leak on my Land cruiser... garage saying it'll cost $9K AUD as engine needs removed due to how timing cover sits sandwiched rather than bolted in. any advice on how easy this is to do by self?

2F valve cover $75 plus the ride

Came off a B-series engine, I think 3B but can’t remember exactly. No idea on compatiblility. $20 plus shipping. Can vapor hone it and make it beautiful for $20 additional

Need for H55 swap. Thx. like this one...