abs

It's happened to me. I'm experiencing the dreaded 'brake failure', and I was hoping compassionate and knowledgable people on this list could help assure me that I'm doing the right thing to respond. (I trust my mechanic, but he's not the best communicator.) Last week, I experiences the...

Has anyone seen a faulty skid control ECU in one of these? I'm having a unique issue with trac in 4wd on my 2005 sequoia SR5. The following situations are all when taking off from a stop going straight ahead. In 4hi, taking off from a stop, the slip light flashes and power is cut momentarily...

I have a 96 lx450. The brakes appear to work fine, but the trouble light for the ABS system comes on about 5-10 seconds after the truck is started and stays on. If I shut off the truck the light resets, then comes back on after restarting the truck. Any suggestions on what might be causing...

Here is the story behind the ABS issue. I recently took my Lexus LX450 to a local shop here at Tucson to get an upgrade to both front and rear differential gears. After the shop had my Lexus for about a week and a half, the shop told me my vehicle was ready. When I got there, I asked if they...

I need a brake line 3 way fitting (maybe called a T fitting?) that fits our 80 series. I tried to order a 90413-10058 (the 3 way fitting that sits under the master cylinder on ABS 80 series) but apparently, those are no longer available. And to be clear, I don't need the bracket that attaches...

I recently purchased a 1993 FZJ80 and discovered it has a faulty right rear wheel sensor. I'm trying to figure out which sensor I need, as there are two parts listed based on different yoke measurements. I was told that the build date will determine which specific sensor is needed (mine was...

Hey everyone, I'm new here, and just purchased my 1st 100-series last week. It's a 2000 LX470 with 250k miles, that I purchased for cheap with the goal of turning it into a DD. Everything runs and drives great, but I had the classic ABS, VSC, A-TRAC, and brake lights on, although brakes were...

To start, I have a 1999 Land Cruiser 100 series, a little over 200k miles. Last year, one day my dad was driving (now my truck) the land cruiser, and the brakes apparently were completely shot. I don't know if it did the screech of death or if he had the 5-6 pumps before hand until they...

Hello all, I have never posted before, so any help would be greatly appreciated. I'll post the TLDR in the first paragraph, and the subsequent paragraphs will be the full detail if anyone wants to know the entire story. I have a 2001 LC, all brake warning lights came on one day. The dealer...

Hi, Just bought an LX470 2002, had been looking for a long time but could gain courage to get one….now got a very good deal that I couldn’t say no….it has 260k miles….has ABS, VSC off, traction control and battery light on….all the breaks are working fine for past few thousands miles…as per the...

While doing nothing cool and only taking my son to school I had an upper ball joint break. For reference I have an Ironman suspension, maybe 2.5”loft with that, with black hawk upper control arms and running 285/70/17 for tires. Other than that I am stock. I had parked on a slight upgrade. When...

I replaced all of my hard lines in my 100 series a couple of months ago. I bled the system according to the instructions from guys on here. While my brakes seem to be working fine, on start up and randomly while driving the pump is making a slower lower pitched almost grinding noise now as...

Hey all- '06 spongy pedal, slowly goes to the floor - no leaks on brake lines, or at calipers, and not losing fluid in reservoir. No screeching pump, ABS or VSC lights. I'm guessing master cylinder seal(s) leaking. I could only find a MC rebuild kit for the 03-04 years, so I bit the bullet...

Since I got my 2001 LX470 in 2020, going around a normal turn at normal speeds (say, a normal 35 MPH road curve) would produce VSC beeping, sometimes even kicking in the ABS for an abrupt forced slowdown. The only code coming up was for steering angle sensor. We replaced and reset that thing...

I have a 1994 fzj80 and it does not have abs brakes. It has front disk and rear drums. I see the abs light in the dash so it must have been an option. Can i add abs to my rig? If so is there a kit i can purchase? Any advice is appreciated. Thx

Hey! I’m a new LX470 owner that I found and bought here in El Paso, TX. I’m experiencing a brake issue that I can’t seem to figure out and would love some help with. I have the ABS LIGHT ON and check engine light on. I’ve replaced all 4 rotors, 4 calipers, ABS motor, and all fuses and relays...

I ordered replacements that were supposed to be compatible with my 2006 LC. I went to replace them and noticed they are different than the ones already on there. They came without the harness. The current ones on the truck have more of a pronounced cylindrical stub (see attached). The...

So the ABS sensor on the driver side wheel is sticking out of the hole it goes into by about 1 cm. I recently did bearings and CV axle and that meant removing rotor, dust shield and the ABS sensor in question. When putting it back, I think I messed up by putting the oil seal for the dust shield...

Hi all. Back again. At Xmas last year I had the ABS brake booster motor in my UZJ100 fail while away on holiday. I posted about that here: ABS warning light and audible alarm, brake failure soon after....possible easy fix to get you going In short, I cleaned out the motor, reinstalled it, and...

1995 FZJ80 Sorry if this has been posted or talked about before, but no matter how much I have searched, I can't find anything about it. We bought this 80 series at our shop, and after inspecting everything, we found out that the previous owner had removed the CDL and ABS bulbs out of the...