1hdft

For sale is 1HD-FT with 188300 km (117004 miles) It comes from HDJ81 Engine starts easily, runs smoothly. Videos will be uploaded later Timing belt was changed at 187035 km Standard 24V starter comes with it, however, can be upgraded to cold climate 12V starter for extra 150USD Standard 80A...

I am selling a complete hdj80 engine. It is a 1hdft 24v version The engine has done 200K miles. Engine is very clean and has no oil leakes. Engine come with alternator and starter, flywheel and clutch. (and propeller, not on photo) If anyone is interested I can startup the engine and makes...

Following @IanB I'm reposting a question here

Hi, Just a quick question, from what I've found a turbo back exhaust for a 1HDT is the same as for a 1HDFT, am I right? Same turbo flange and mounts. Thanks Cheers

So, a short bit of backstory. Truck is a 95 HDJ81, exhaust is new(er) 3" from the cat back, and was put on in Japan before I got the vehicle here. The section from the turbo dump to the cat is still the old 2.5". In the "two birds with one stone" school of thought, I'm getting rid of the...

Hello, I have a complete 1HDFT 24-valves with all the electronics and accesories surrounding the engine. I want trnsplant it into 2004 105 with 1HZ engine. A few questions: - Does somebody did it before? - What problems I should expect? - Does a menual gear will fit? Thanks

Hi all I'm new to this so please excuse me if this the wrong forum, I've got a stock 1hdft 80 series manual with 380,000km on it in great condition over serviced if anything. It's our family car shopping trolley and touring set up, I've had it for 15 years brought my children home from hospital...

Hello, I've searched and searched without any luck. Long story short, I'm wrapping up my 1HD-FT engine refresh. Need the specs for the correct amount of pressure the fuel nozzles should have. The FSM does not show what pressure it should be. It mentions a start to spray pressure of 2000+ PSI...

Does anyone have pictures of a 3" turbo back exhaust in a 60? Can it go inside the frame rails?

Sold