Recent content by Yavo

Will do when I get home from work.

For sale is my 1999 Lexus LX 470. Clean title. The bad: It does crank over, but I cannot get the stupid thing to start. I am getting a "B2796 code: No Communication In Immobilizer System.” I replaced the key antenna, amplifier, and ECU, without any luck. The immobilizer light is not flashing...

99 LX470, BTW...

The truck would intermittently not start over the past few weeks. Finally died and I had to get a tow home. Pulled the code and am getting "P2796 No Communication In Immobilizer System." I could put the key in the ignition and the security light went out. I tried testing the ECU relay and...

I have one, and I also happen to be in Cinci... PM me.

Both the rack and pump are OEM. Bought from McGeorge Toyota.

PS pump is less than six months old.

That is a good thought... When I pulled the rack, I could not disconnect the column at the rack and had to pull the whole column out by disconnecting the upper shaft link. The thing is, the column u-joint is not part of the column shaft I pulled... What part do you think may be binding?

I cleaned the reservoir and did a full system flush about six months ago when I replace the loud PS pump. When I got the new rack, it came with two black plugs that went into the female hardline connectors for the PS pump lines. I made sure to remove them and check that the holes were clear...

More detail --> Part of my troubleshooting was to pull the reservoir return line, hook up a six foot hose to it, and lay the end of that hose in a five gallon bucket. My girl was topping off the reservoir during the engine-off flush. It appeared that I was getting flow into the bucket when I...

Hi All, First post here, though I have been lurking for a long time. I went through the pain of replacing the steering rack on my ’99 LX, but now I have an issue. I have ZERO play in the wheel, which is awesome. However, now it is like I have manual steering… With the front wheels off the...

I LOVE that color on a 100.

I'll second this. With the correct tool, it is a piece of cake. Here is what I used: OEMTOOLS 27178 Master Inner Tie Rod Tool Set https://www.amazon.com/dp/B01MS7FD62/ref=cm_sw_r_cp_apa_dpIwAbD27THFV

@reevesci Have you started offering the Cruisin Offroad mounting style yet?

How is the wrap holding up? Edit: Nice wheels, btw... :D