Recent content by TimG

I'm in Melbourne Australia.. do you have the print files or do you just sell the parts and if so how much for the cost of the part and postage to Melbourne Australia please.

Hi Everyone, I love this stuff and I have just purchased an Ender3v2 for making stuff for around the house and a few parts for my 1992 80 Series Landcruiser and I am having problems finding a part for the front A pillar grab handle .... I have looked everywhere to find a print file or something...

Hi everyone, I'm in Melbourne Australia and all of your posts seem to be from people in the USA. I have read through all of this and my issue is I have a 1992 wagon with barn doors and the rego plate is off to the left on the small door which would place the camera way off to the left.. I do not...

Whoo hooo another few Aussies here on this page, great to see. I have been unemployed for many years with a back problem and have scored my 80 series at a bargain price from a friend a few years ago and like you in the process of setting it up to go touring and Geocaching around Australia in the...

I recently scored from a FB group I'm in, the bucket seats from a '94 model and the centre console for a bargain price, as mine had no storage other than the glove box and ashtray which I don't use as I don't smoke, I finally got rid of that pain in the ass front passenger side 3/4 bench seat...

I would totally agree with the above poster. If you adjust your handbrake correctly and maintain it then there should be no need for an aftermarket item. I have mine adjusted correctly and it holds my vehicle just fine on an incline. If you need to due to age or wear (remember cables stretch...

I have the Aussie povo pack... consisting of grey vinyl floors, 5 sp manual, no 3rd row seats, the second row seats are grey and dark blue vinyl also, no sliding windows at the back and 4 wind up windows, 1hz motor non turbo, it had until I recently changed the front seats it was a drivers side...

I have a similar issue trying to get the current stereo out.. which is not like this one but the same problem. I have seen a few utube vids showing that you have to unscrew some screws at the bottom of the console and some at the top under the top dash piece to remove the dash face plate which...

Why don't you ring them and ask about the tint. Would that not be an obvious answer ??

You could also use something like any of these which are easy to fit and some come already with wires so you just have to quickly solder and then cover with heat shrink. You could also combine an LED light with these. https://www.electronicsurplus.com/3-410-switch-leaf-nc-package-of-4...

What about just a normal pressure switch that you can buy from any electronics shop or online, or a door pressure switch for the interior lights ??

I've just made some of these terminal plates for my cruiser as I am unemployed and lots of things are out of my price range and hey if I can make it then why not. They are made from Galvanised plate strip and cut into lengths with a hole to fit the terminal bolt and then 2 holes tapped for small...

Wow I wish I had come across this ages ago.. If anyone can help me please ... I'm looking for an A-pillar grab handle to fit the left side of an 11/92 cruiser. I'm An Aussie so it needs to be the left handed passenger side version for those of your over there in America... haha.. ;)

I've searched the search bar and not found things at times, but here in Australia I use eBay, Pinterest, and Gumtree (Australian type of craigslist) and can usually find info and items I want on those. Try doing more of a search using less wording in your search's, look at more avenues of pages...

I just saw this and I've done something similar on my rear passenger quarter panel. Not used any of that hard stuff just normal car bog and undercoat then I'll paint it later.. Luckily, I don't have any rust spots as bad as yours. I watched your vid on the tube, liked, commented and subbed ;)...