Recent content by TILLOTSON

https://roninmetal.com/products/1998-2007-toyota-land-cruiser-100-series-ditch-light-bracket?srsltid=AfmBOopjGjhWJ1XUHFnqqgj3xpf_wEbEy__OMzxVRiiu1fpiGqCwYeOm

I can’t thank you guys enough, great info to go on. I think I’ll probably just do a new radiator. Don’t really want to have it fail on me. I’ll figure out how to check for cross contamination… really hope not. Didn’t see any pink frothyness on the transmission dip stick.

I believe this is the transmission fluid inlet to the radiator. Has developed a leak. I cleaned it off and ran it for a few minutes developing this drip. Tried to tighten the fitting and it seems to spin and not really tighten up. Same with the other trans fluid fitting on the other side of...

Mean to update this sooner but I was considering trying to problem solve a little more before I did. I got the new headers, cats, and cat back installed a few months or so ago. Man I do not like doing the headers. Not too bad going in though. With the design I had to use ratcheting...

Anyone actually tow off a hitch bolted to the rear crossmember? I have a coastal bumper as well and would like to move the hitch up to the cross member instead of the stock frame mounted. My trailer is only 1250lbs so not going to get close to max towing capacity.

I ordered the full system. Rhino was responsive, gave the same quote, and sent a PayPal invoice for payment. Shipping was fast, I ordered and figured it would be a while. It was around a week. The packaging was not great. There were several areas where the coating had been worn through to...

I’m looking forward to hearing how it works out. Very tempting to order that setup.

It took mine a little time and weight back there (steel bumper) to settle in.

Would you have any interest in selling the Dough Thorley exhaust separately?

Ironman sells an LED replacement. I’m curious if anyone has found other options as well.

I took mine to get an alignment after installing Ironman suspension. They couldn’t do an alignment with the condition of the steering rack. I forget what they said exactly, but between what they told me and some research on this forum I ended up replacing the steering rack bushings and then...

How did you screw that in? Just self tapping screws or did you get nuts under the dash? Or?

I did an install of the foam cell pro kit from ironman a year or two ago. I used the information I got from this forum. Huge help. One thing that was a giant pain was getting the stock rear shocks off. I'd definitely look at those threads. I think there was also an OTRAM youtube video that...

I went with the foam cell pro. Very happy with the ride, but I haven’t tried other brands to compare

I remember it being a pain. I made it work with a good sized pry bar. Figure which side of the bar would be easier to pry against, put a bolt in the opposite side. This was one of those jobs that sounded and looked easy, but was a struggle and took way longer than it should to get a bolt in.