Recent content by socalmtbiker

I’ve had the grom Vline since 2016. Updated etc and always never had good luck with phone calls with issues exactly as you described. I think I contacted grom and they explained mic gain solution however it didn’t improve. Since then I just use the iPhone speaker as you did. The rig is not my...

Detour to Diablo drop off on my way to Fallbrook.

I last posted in September 2020 about this issue. No problems since. This time a drive from San Diego to bishop on all freeway. Temp 90-105s, elevation 4K, 7hr of driving, towing oof road trailer and loaded. My first refuel no issues. I did notice pressure when opening the gas cap but not...

can this be welded?

Did you purchase a sheet and cut the design yourself?

I'm thinking about the wolfbox. How are you liking it? Also, where did you mount your rear camera?

Eastern Sierra during the beginning of fall

Timing belt, water pump, cam seals, alternator brushes, radiator, etc. The ac bolts were a PITA.

Taken the day I posted, yesterday. This north lake, Lake Sabrina is beautiful. Going to convict lake today. Mono county has an Instagram page that tells you where some of the best fall colors are up by mono lake. Have a good time with your family.

Eastern Sierra's

Thought I’d take a quick trip shooting. Heading home -Ih8mud. Got stuck and was digging until a tundra (my anchor) came by and I winched myself out. Not even a quarter mile I had a quick air loss and found a rock had made a hole in my rim. Short trip took a few hours…

Went with DuroBumps in the rear position and got out to Anza-Borrego.

Working with aluminum was harder than I anticipated. I found some scrap 1/4 thick aluminum for $50. I purchased Sherpa roof rack mount feet & Stainless steel mounting hardware as well as Tnutz aluminum extrusions. About 500 in.

Finally got wiring done. Took a while fabricating brackets for the switch pro buttons, another bracket for main kill switch for the winch and winch relocation mount. Almost time for timing belt service.

Wanted Baja designs s2 on my dissent v1 aluminum bumper. Practice some tig and fabricates some brackets, cut up some plexiglass, and got them in. Have to make a bracket and install my switch pro and get everything wired up.