Recent content by Rebele92

Installed the 3D cup holder from cruiser designs in the LX. Also dropped the U-Haul brand hitch receiver frame to make room for a 33” spare underneath. I had a replacement from Curt that was supposed to allow room for the 33” spare but the one Curt sent didn’t fit and all the bolt holes didn’t...

Bingo

Will it allow a 33” spare uunderneath ?

What is this connector?

Folks I have a 97 LX and the passenger side power seat will not tilt up or down all the way. I am not talking about the seat back, but rather the seat bottom that activates by moving the seat forward /backaward handle by tipping it up or down. I look under the seat when I'm activating the tilt...

Well stock is +60 mm offset, and 1.25 inches is about 40 mm , so that makes you run equivalent of +20mm offset

What year did Toyota start selling LC with R134 in US?

Toy - Lex in Kemah

I did it , method 706, bronze, 17” +35, BF KO285/70/17. No rub. 2.5 inch lift.

Is anyone running the method 706 with +35 offset? I’m looking for pictures and experiences / comments particularly with a 17” and 285/70/17.

17 or 18?

17 “ or 18” are these +35 offset?

Are these 706? With +35 offset ? 17”?

Thanks for the follow up

So was the spacer what was required to be able to put the caps on due to the hub poking out?