Recent content by paco01

  1. paco01

    100 Series HVAC Controller - NAV DELETE - (OEM+)

    Following and fingers crossed.
  2. paco01

    Who wants upgraded AHC torsion bars?

    I'd be down for a set.
  3. paco01

    Arizona Classifieds / For Sale / Wanted

    I have an OEM rack from my 06. Thinking of letting it go.
  4. paco01

    What have you done to your 100 Series this week?

    Nice on doing your own. I'm following your build. Hope your power gets restored soon.
  5. paco01

    What have you done to your 100 Series this week?

    I remember that feeling. Did you go with the Huracan Fab kit?
  6. paco01

    What have you done to your 100 Series this week?

    Installed Airlift 1000 bags yesterday. Filled them up to 25psi to test overnight. Holding air fine so far. Looking forward to seeing how they handle on our next trip.
  7. paco01

    What have you done to your 100 Series this week?

    I installed this unit a few months ago since my swing outs obscure the rear view. Loving it so far. The front camera is on the rear of the mirror/display, so it may be a little high up you for you to see over the hood + any armor you might have. I've been considering adding a small wireless unit...
  8. paco01

    ARB Base Rack photos

    I ran mine up light bar wiring up the A pillar on the driver's side, tucking it into the OEM windshield moulding. Have since added ARB rack lights as well running down the same area with the KC HiLites Universal Wire Holder. It's too dark now to snap a pic, but I can post one tomorrow if you...
  9. paco01

    ARB Base Rack photos

    I've had the exact setup you described for a couple of years. Very happy with the rack and the system in general. There's minimal noise with the deflector installed. Just know you're buying in to a system, not just the rack. It's a solid system. Here's a pic.
  10. paco01

    What have you done to your 100 Series this week?

    Where did you order from? I ordered some last month only to have the order cancelled due to supply chain issues. TIA!
  11. paco01

    Help with ARB Compressor switch wiring (under hood install)

    Thank you. Good point — I'm not concerned about illumination of the switch under the hood. I appreciate it!
  12. paco01

    Help with ARB Compressor switch wiring (under hood install)

    Thank you. It's an 06 with AHC. I'll update my signature line. Much appreciated.
  13. paco01

    Help with ARB Compressor switch wiring (under hood install)

    Thanks for your message. Yes, it's all a part of the loom, but I need to source power to activate/power the switch with the red/orange wire and illuminate it with the blue/white wire. I've found examples of how to do that when running the switch into the cabin, but nothing on powering it from a...
Back
Top Bottom