Recent content by nosam

Took it om Tuesday for valve cover gaskets and spark plugs to be replaced. Dealer called an hour later saying the CV boots were cracked. So had those done too. Nothing like a $3K repair bill for the holidays! That should be the last of the major maintenance stuff needs for another 100K.

I was looking around the back of my 100 the other day while installing the M16V1 I ordered a few weeks ago and got to wondering if Ben (or anyone else maybe?) had ever thought about some sort of replacement piece for the 3rd row cupholder or the small storage space panel behind it? Seems like...

Reach out to Daniel Stern Lighting Consultancy and Supply - https://www.danielsternlighting.com/ I found his info here on Mud and he gave me some great advise on things to check with my headlamp housings as well as style of bulbs to upgrade too.

Heater T's. The driver's side had been seeping for a few moths so I knew it was getting bad. It came apart when I pulled.

Replaced the factory head unit and GROM BT module with a Boss HU and backup camera I bought almost 2 years ago. Also replaced the antenna mast that got broken in the carwash with a new one also purchased around the same time.

Are you going to have the AHC switch panel for the Ram mounts in stock soon? I have the ball and everything already.

I just discovered this thread. I have a 99LC originally from S. Cali. Went out and inspected the doors. No signs of metal stress or failure yet, but I did spray all 4 with some P Blaster Dry Silicone to hopefully stave off any future issue.

I thought I had done the twist right the other day. Went out and pulled it up, twisted more so, pressed again and it seems to have seated back correctly. just user error! thanks!

@CruiserDM Received my cupholder last week and put it in yesterday. One small thing i ran into was the cupholder itself seems to be bottoming out on the crossbar underneath and won't let the console panel snap all the way back into place. Not sure if this was anything you had run into before or...

Well now i'm just picturing some crazy steampunk/MadMax looking setup!!! :rofl:

I've tinkered some with electronics projects for years. mostly guitar effects pedals. So my understanding is minimal I admit. Could you possibly desolder the mechanical switches from the board, then solder on wire leads to whatever new location you want the new switch to be in and connect a...

Wish there was a way to relocate the CDL and Hazard switches separately. The CDL could go in that blank space between the rear blower and window defrost it seems, not sure where the hazard could go though. But if they could be moved then a M2V2 could be mounted on both sides. Just got my M2V2...

I've been checking the website for months hoping for the 100 series sets to be available again. I'm in for a set as soon as they are ready.

Tried hunting around on the forum, but not having much luck. So I installed a GROM Toyob3 bluetooth unit today. Everything went smoothly. Tested before and after reassembling the dash. Worked great. Then I ran one of these to power my dashcam. I ran it down to the driver's side kick and used...

This is the same behavior my '99LC exhibits with the only key I have. Light flashes when inserted, but turn to first position and light immediately goes out. I have not been able to add a new key either. I'm going to try the programming sequence while turning keys to the first position and see...