Recent content by mdw83fj60

https://forum.ih8mud.com/threads/f-2f-3f-and-3fe-rear-main-seal-oil-pan-gasket-and-clutch-installation-instructions.1338727/ Post # 11 in this thread. I agree with @bhsdriller , I have an easier time using google to find info I need most the time.

FWIW , I had both my distributor and carb rebuilt by JIm C , at different times. Distributor took 3 months to get back, Carb took 6 months to get back. Both times I initially emailed him, no response, so I called and talk to him on phone. In my opinion well worth the wait.

The only issue I had was when transferring over this bracket to the seatbeltplanet retractor, I have an 83 FJ 60 and the bracket was held on by star drive bolts that threaded directly onto the retractor. The SP retractor had the holes but they were not threaded and the kit came with all kinds of...

Replaced my front seat belts with some from SeatbeltPlanet. I also installed a wolfbox rear camera, I have one on my tundra and love it. Now when the back is full of whatever, which seems to be most of the time I can still see out.

Bump to $140

Definitely not going to use it for long periods of time, but to stretch that gas pedal foot every so often on long drives. Might be the best 50 dollars I have spent on my FJ 60.

Recently drove 260 miles to go camping, not far, but far enough to realize that holding the gas pedal really makes my ankle start to ache. The cruiser drove great my gas pedal foot was the only issue. So dug up this old thread, ordered the cable. Took about 40 minutes to install, super easy. I...

Drivers side rear brake was dragging, so decided to tear into that. Found the bell crank was pretty froze up so cleaned and greased it up. Love an easy , cheap fix, just cost me time.

Bump

What they said 👆. I had very similar problem as you describe, this is what my drivers side motor mount looked like when I replaced it a few years ago. In two pieces and soaked in power steering fluid. Very straightforward job to tackle.

Bump

Replaced front and rear shocks.

I have two Bilstein 33-230351 for sale barely used, was on FJ 60 for about 30 miles. ( replaced because I measured wrong shock didn’t work with my lift ). Like stated above nearly new condition. My mistake your gain $ 165.00 shipping included.

Yes, it’s supposed to help with corrosion. My first Mishimoto developed a leak after 3 years.( luckily it was covered by warranty) I don’t know the exact cause but trying to cover all the bases, added this and a couple ground straps. It is a tight fit to get that anode into the neck and out but...

I know this one fits, its rate at 13 lbs. I run it on my Mishimoto radiator, it does have a sacrificial anode attached that can be used or easily removed. https://ebay.us/m/FZ8nJD