Recent content by madisonr34

Sorry to hear that. Make absolutely sure they use Toyota OEM seals and check the bronze bushings for play.

I used the $$$ Red line grease before, and it separated a lot in the container, I tossed it and used Valvoline. My Valvoline grease has not separated in years. All you need to do to check if your knuckles are leaking is pop off the cap at the end of knuckle. If its leaking, the birf soup will...

I have over 300k on my original head gasket. I'm sure there are other factors that causes head gasket failures in these engines such as the EGR system. I took my EGR off a long time ago. Another thing I've noticed in my years own an 80 is that there is some type of solid grey matter builds...

Guys I just want to report that I was able to achieve readiness by using a different value resistor and then use the HUDDEXPO PLUG to keep the light off. No erg sensor installed or modulator. I ordered a resistor kit for around $5 from Amazon then I used a paper clip and some alligator clips...

Hello, my fellow mudders, I have a suspension problem and would like to get some insight from the suspension gurus. My 97 FZJ80 rocks back and forth dangerously when my suspension loads and unloads at freeway speeds. For example, exiting a wide turn on freeway or a sudden lane change. This...

I used 2 universal CARB catalytic converters, and they don't work... fortunately you can still pass smog in California without the cat monitors ready. Big headache still...

Just weld some tabs to back and mount away

Can you make me one that puts that mount on top of frame rails? I want my winch to sit higher up in front of the grill.

80 door speakers are shallow mount speakers, you will find very limited choices. I was having issues with my driver door speaker not working. The factory 80s stereo wiring is all over the place. I have the factory electrical wiring book and none of the color wires match. I ended up running a...

For what its worth, I got the Delphi pump from Rock Auto. Almost 5K miles on the Delphi pump. 319K on the OEM pump and still ran when I pulled it. I figured @ 300K i better start changing somethings before they fail.

Does anyone know if some one makes a high mount winch plate? The TG winch plate sits to low for me. Thanks.

Hello How much shipped to 95824. You can cut them smaller. I can weld them back together. Thank you

Sub'd. I will need this in a couple months.

Looking for a good used set of catalytic converters for a 1996 or 1997. Mine were stolen. Please let me know.

I went ahead and bypassed the radiator using a Deral stacked plate cooler and autometer ATF temp gauge...hot at idle between 120-150 degrees. Temps rise very fast at stop lights. Moving she runs down to 80 degrees. This is Calfornia weather.