Recent content by highkick05

Don't bother with the thermo fans, it did nothing for my AC. I ended up replacing the entire AC system minus the hard lines. Thats new condenser, evap, tx valve, sensors . AC compressor .. blower fan, blower resister. everything Worked like a dream before I sold it.

Not that I know of. You could hit up the free workshop manual at LC100 Workshop Manual - https://lc100e.github.io/ Just look up replacement of each individual component. Should have the orings that need doing. Like I said, any that you can't match go to the AC shop and see if they have. It's...

No oring kit. Any you can't find , just go to an AC shop. Take the old ones and have them match them. That's how I did it, they had no issue giving me o-rings because I was getting them to take the old gas out and the refill it (part of the job they said).

Have not seen it break like that before :lol:. Put the right amount of force in the right area and it wouldn't surprise me. Yeah, I have been lazy and put holes in some of those plastic weathershields and have noticed water comes in on my front driver speaker. I mean to tidy that up properly...

Yeop, so when you cut the centre divider, just make sure it is measured up and you cut it so NO air can escape through any holes through/before it hits the filters. Best way to know if you've done a good cut, is put the filters in, and if they are a snug and little hard to push in -- you've got...

nice hot soldering iron would suffice

Those Australia Evap box's you're looking at too with the centre section -- never ever had cabin filter manufactured/designed ever buy anyone in Toyota or the aftermarket business(s).

Yep, that centre bit can be cut out with the evap in or out. But you need to be accurate or air will follow the point of least resistance and go around the air filter rather than flow through it into the vents. So happy to get the full filter in though. Air quality in 20 year old cruisers sux...

the manuelle is confusing: in the shop it states GL-4/5 should not be used in transfer case's but here we are in toyota manuelle And I get it, I don't need to go thicker! But as per engine's going thicker seems to protect the engine more and stop oil burning/going through to the exhaust. I...

Thoughts on front and rear diff and transfer case oil on my 105 series solid axle (nonIFS). I run 50mm lift and 35s Cooper MTs, and have quite a bit of road vibration through the vehicle. Manual says GL-4 or GL-5 for diffs. Should I be looking @ higher viscosity oils? GL-5 states 75W-85 Transfer...

Yeah they look tiny , cheers

Seems the 105 series they couldnt be bothered cutting the centre part out of the box. I had to do that myself then viola they both went in perfect. One day I will understand what models have what :cool: (maybe lol)

Hi, just wondering ARE these worth investing in, or should I just place tweeters in the front Left and Right bottom windscreen areas. I guess I'm also asking what is better placement as well / are they good in these / do most tweeters fit in side these:

Could you fit the entire (long/only manufactured) cabin filters in the housing? Or did you need to cut the mid section out to fit them in? So many variants it seems.

Put on 3 genuine from partsouq door handles - all but the drivers DH. Ripped the drivers door card off anyway to check my speaker which is on the nose. Those speakers sit really close to the door card, looks like I've hit the door once or twice and broken the centre part of the speaker. Going to...