Recent content by craigrou

Nvm I found it. Thanks!

I can’t seem to find it. Any chance you would share with a pm? Thanks.

Stuck in limbo. Verified with local Birmingham dealer that my ‘83 60 was in need of the tank and belts. They got the tank, but I had to get the lines (thanks @crusiermatt). Told me it would take 1-2 days. When I called after a week they told me they had completed the job but they were keeping...

Was reading up on your DIY and hoping you got to install this setup? Any insight or update?? Thanks!

Trying to get some insight on the venting system. Would anyone have any idea why I would be getting raw fuel up the vent line at the firewall? Would it be because the vent hoses have failed? Thanks!

Yes i have actually stumbled into the threads that are showing off his kit. I think that will be in the future for sure, just curious if anyone had insight as to how the fuel is making its way up the vent line. Dont want to go through the whole process of replacing lines and then still having...

Digging this back up because I seem to have the same issue. Seems like the OP problem never publicly got solved so trying again. I have an 83 60 with a SBC and the vent line was plugged with a bolt when I got the car. I have been having recent fuel issues with the vehicle surging under load and...

Long shot, but hoping someone could help. Rebuilding parts of the suspension on my 60. I ordered all new bushings from Energy Suspension and ARB Add a leafs for rears. For reference, I have aftermarket lifted shackles (rears are 5.5 and fronts are 4.5). Dont know brand or anything about them as...

Bumping this thread again to ask if @thundercatss or anyone else could give insight to how the tacoma set up feels? I have a set of 4600's from a 2023 Tacoma for 100 bucks waiting to be purchased, but wanted to see if there was any downside to doing the swap? Planning to keep lexus front coils...

Revisiting this post because I too have only the right rear door not working. Was able to get the switch out and it appears there’s no power coming through that wire. Any thoughts on how to see where it attaches? Thanks!

Any chance you still have the steering shaft protector? Thanks!

Preview attachment IMG_4730.jpg IMG_4730.jpg 171 KB Not sure how visible it is, but the threads stop before they bottom out in the fitting. Gonna send back and try a different brand i suppose?

Hi all, I recently had what I thought was a blown out master clutch cylinder. I ordered a new Aisin CMT012 from Rock Auto and installed it. I tightened it down and went to bleed it and noticed it was leaking terribly from the fitting. I took it back off and compared to the old MC and noticed...

Thanks guys thats super helpful. Will go for the install as is!

Hey guys, about to do the Saginaw pump conversion but wasnt sure about the need for reducing the pressure to prevent the "twitchy" highway characteristics? I have read the thread here LS Swap: GM P-pump to Toyota Steering Box - Flow Control Fitting -...