Recent content by Cetus

Hi all, Hoping for some help. I recently installed the ARB front bumper and decided to go with the ARB fogs since they're direct fit. I used the factory harness to wire the foglights so I have on/off control from the light stalk. The polarity is correct and is getting 12v but the foglight...

My LX front end doesn’t feel as tight and there’s a squeak with minor clicking noise. Based on my research it seems to be the lower ball joints. I’d like to just change things out. I remember there was a package with all bushings and ball joints with control arms. Where can I get this? Thanks...

I just received my GROM and after seeing this video I'm very excited and anxious to get it installed.

Nope, physics are the same as in Texas. It's just to avoid the transmission shifting from 1st to 2nd while in traffic. Too often, while in traffic, by the time it shifts to 2nd the vehicle has to be stopped. So to avoid that I'll just use the 2nd start and drive through traffic. Hope your...

If you live in the SF Bay Area you’ll know. Give it a try.

I started using the 2nd start button during bumper to bumper traffic, it keeps engine in lower revs and less torque.

How would you compare the Toyos to the Continentals? Which one you like more?

I'm running the Continental Terrain Contacts and they've been great so far. No noise at all and don't notice much of a change in gas mileage. It's a light AT tire that is rated pretty good in wet and snow so that's why I went with them, and I spend about 90% on pavement. I plan to overland...

I had the same issue and cranked my torsion bars until in spec. That barely increased the ticks in my reservoir but my circumstance may be little different from yours. I ended up replacing all 4 globes and the ride is amazing again. My rear pressure is still little high and my front pressure is...

I had the same issues. The ride was bouncy and harsh. I replace all 4 globes and the ride is awesome again. I had about 6-7 graduations from low to high. Now I'm at about 14 graduations.

Same reason I'm going with Dissent. I also really like how it looks. I'll adjust the height if needed and hold off on torsion bar adjustments. If I adjust the fronts now the rears might be more out of spec after.

Thank you. I'll measure the height again to see where they're at now. I know they were just a bit lower than spec prior to replacing the globes but not by much. Will need to review the procedures on how to adjust the height sensors. I also plan on installing a Dissent bumper in the near...

The AHC is working great after replacing all the globes and the ride is nice and smooth. I finally hooked up tech stream to check pressures. This is what they are now. Front 5.5 Rear 6.8 Does it seem like the front is too low? Or is it safe to keep as is? I want to make sure it's completely...

My AHC was riding really rough and bouncy for past few months. Thanks to the great info in this thread I was able to find a source for the globes, wrench frompep boys, and instructions to replace globes. The truck is so smooth again, like a brand new truck. Love the AHC.

Little background on how I ended up purchasing my own silver LX. My dad's TR4 overheated at 386k after an accident so me amd my sister bought the 03 LX in blue vapor metallic for him. I liked it so much that I sold my audi and picked mine up. So this happened the other day. My dad was driving...