AHC pressures

[Cetus]

The AHC is working great after replacing all the globes and the ride is nice and smooth. I finally hooked up tech stream to check pressures. This is what they are now.

Front 5.5
Rear 6.8

Does it seem like the front is too low? Or is it safe to keep as is? I want to make sure it's completely dialed in. Any help will be much appreciated.

 

[suprarx7nut]

Target is 6.8 Front; 6.1 Rear. Your front is too low.

I don't think you'll damage anything, but the ride might be a little stiffer/springy than it needs to be.

If you have correct height at front and rear, you may want to adjust torsion bars to pull that front pressure up. If your height is too low, raise that front sensor up a bit until height is in spec and recheck pressures.

 

[Cetus]

Target is 6.8 Front; 6.1 Rear. Your front is too low.

I don't think you'll damage anything, but the ride might be a little stiffer/springy than it needs to be.

If you have correct height at front and rear, you may want to adjust torsion bars to pull that front pressure up. If your height is too low, raise that front sensor up a bit until height is in spec and recheck pressures.

Thank you. I'll measure the height again to see where they're at now. I know they were just a bit lower than spec prior to replacing the globes but not by much. Will need to review the procedures on how to adjust the height sensors.

I also plan on installing a Dissent bumper in the near future. I wonder if that will increase the pressures close to front target spec at 6.8?

 

[suprarx7nut]

Thank you. I'll measure the height again to see where they're at now. I know they were just a bit lower than spec prior to replacing the globes but not by much. Will need to review the procedures on how to adjust the height sensors.

I also plan on installing a Dissent bumper in the near future. I wonder if that will increase the pressures close to front target spec at 6.8?

Triple check the process for the sensors. There are two ways to adjust it with subtle differences, but you'll want to make sure you use the correct method.

If you're getting a bumper soon, I'd hold off on adjustments. Get the bumper on and re-evaluate. Pressures will definitely change.

I've got an aluminum set of armor from Dissent on the way. I went with aluminum for the sake of AHC.

 

[Cetus]

Triple check the process for the sensors. There are two ways to adjust it with subtle differences, but you'll want to make sure you use the correct method.

If you're getting a bumper soon, I'd hold off on adjustments. Get the bumper on and re-evaluate. Pressures will definitely change.

I've got an aluminum set of armor from Dissent on the way. I went with aluminum for the sake of AHC.

Same reason I'm going with Dissent. I also really like how it looks. I'll adjust the height if needed and hold off on torsion bar adjustments. If I adjust the fronts now the rears might be more out of spec after.