Recent content by Aeneiad

Up for sale is my 1997 40th Anniversary Edition, factory 3x locked 80 series with 272,XXX miles on it. I purchased it in August of 2020 with the intention of keeping it for many years, but recent health issues and a new job opportunity have prevented me from seeing everything through. I’m...

How was the snow up there? I’m planning on heading up to the Chippewa National Forest the week after Christmas and then make my way into the Superior National Forest. Were the roads and trails passable?

LCR4WD has a lot of good reviews on here but I'd be interested in some other recommendations being I'm north of Brainerd.

If you look at the heater control valve, you'll notice a cable that is clipped to it and it should be adjusted so that the swing arm of the valve is about 4mm from the stop. That cable runs to a servo motor that is located in the dash directly behind the radio. This end of the cable secures to...

I have a 97. These should fit your 96.

I bought a set from eBay and my SO bought me a set for my birthday. Needless to say, I have to go with the set that my SO purchased. These are brand new and have not been mounted; the plastic wrap is still on the lenses. They take an H1 and an H4 bulb but you'll need to provide a wiring...

Looks like a great trip! We are going to be making the drive from MN to UT later this summer so it's good to see some pictures of the areas on our bucket list.

Mounted, but never wired up or used ARB 24v dual compressor. I'm going a different route which is why I'm selling. $500 shipped, Venmo preferred or buyer covers the fees if PayPal is used.

That's your fusible link and you need a new one. They are cheap so get two, one to replace the old one and one as a spare. All 3 from the fusible link are factory connected and go to the positive terminal. Seriously...yours is trashed - get a new one. Part Number 90982-08264

Over the last couple of weeks I've installed a new rear sway bar, LCP rear sway bar links, an ARB front bumper, a Comeup Seal Slim 12.5 winch, and a set of Baja Design LP6s. This weekend instead of working on it, we took it out and enjoyed a few days exploring the Chippewa National Forest.

I decided to go in a different direction with my front bumper. Other than being a little dirty, the bumper and winch are in excellent condition. The winch is the X20 12k winch. The remote is not picture but it is included. The fog lights and the indicator lights on the bumper are new and...

Now that MN temps are consistently above freezing, I'm in need of my AC unit. Since I bought it last October, the AC has been unimpressive. I did some research and came across the easy fix in the thread below and figured I would check the setting on my hot water valve. Being the valve was...

I know this post is a little old, but did you get the 12.5 installed in bumper? If so, did you need to trim the tabs for the lights?

I feel your pain. When I did mine I had to do it 3 times. The first time was to fix a leak on the front driver's side of the pan. When I reinstalled the pan I the last bolt broke on me so I had to start all over again. After drilling and tapping a bigger hole, I reinstalled the pan and a...

I had the same question so I reached out to Delta and was told that the rear crossmember was needed in order to slide the bumper onto. Both Delta and Slee post their instructions online and you can see that the crossmember is needed. I've done a few searches and there are a few threads with...